Philips MCD703 Getting Started, Setting up the TV, Using the Remote Control to operate the Player

Getting Started

Step 1: Inserting batteries into the Remote Control

3

1

2

1Open the battery compartment.

2Insert two AAA batteries following the indications (+/-) inside the compartment.

3Close the cover.

Using the Remote Control to operate

the Player

1Switch the DVD system on and then select DISC source. (See “Switching the system on/off”).

2Turn on the TV and set to the correct video-in channel.You should see the blue Philips DVD background screen on the TV.

➜Usually these channels are between the lowest and highest channels and may be called FRONT, A/V IN, or VIDEO. See your TV manual for more details.

➜Or, you may go to channel 1 on your TV, then press the Channel down button repeatedly until you see the Video In channel.

➜Or, the TV Remote Control may have a button or switch that chooses different video modes.

➜Or, set the TV to channel 3 or 4 if you are using an RF modulator.

English

1Aim the Remote Control

directly at the remote sensor	STANDBY-ON
(IR) on the front panel.	IR SENSOR

2Do not put any objects

between the Remote Control and the DVD Player while operating the DVD Player.

CAUTION!

–Remove batteries if they

are exhausted or if the Remote Control is not being used for a long time.

–Do not use old and new or different types of batteries in combination.

–Batteries contain chemical substances, so they should be disposed of properly.

Step 2: Setting up the TV

IMPORTANT!

–Make sure you have completed all the necessary connections. (See “Connecting TV”).

–In order for a DVD disc to play on this Player, the colour system of the Disc, the TV and the DVD Player should match.

Setting up Progressive Scan feature (for

Progressive Scan TV only)

The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system).With nearly double the number of lines, progressive scan offers higher picture resolution and quality.

IMPORTANT!

Before enabling the progressive scan feature, you must ensure:

1)Your TV can accept progressive signals, a progressive scan TV is required.

2)You have connected the DVD player to your TV using Y Pb Pr (see page 12.)

1Turn on your TV.

2Turn off your TV progressive scan mode or turn on interlaced mode (refer to your TV user manual).

3Press ECO POWER/STANDBY ON B (B on the remote) to turn on the DVD player.

4Select the correct Video Input channel.

➜ The DVD background screen appears on the TV.

5Press SYSTEM.

17