15

English

SUBWOOFER (MX 960D, MX 980D only)

1STANDBY-ON y............Switches the subwoofer on and
to standby.
2..........................................Status light.
3CUT OFF FREQUENCY...Adjusts the frequency range
reproduced by the subwoofer.
4SUBWOOFERLEVEL CONTROL
Adjusts the volume of the
subwoofer.
5PHASESELECTOR .........Selects the best bass
reproduction.
6SUBWOOFERIN ............Connect to SUBWOOFER
PRE-OUT at the receiver.
7SOURCESELECTOR ......Selects the used signal input.
Keep at the SUBWOOFERIN
position if the receiver is
connected as described below.
8AC MAINS......................After all other connections
have been made, connect the
power cord to AC MAINS and to
the power outlet.
9SPEAKER OUT...............Not used with the receiver
supplied.
0SPEAKERIN ...................Not used with the receiver
supplied.
The type plate is located on the rear of the subwoofer.
1Use the cinch cable supplied to connect SUBWOOFER IN to
SUBWOOFER PRE-OUT at the receiver.
2Check whether the power voltage as shown on the type
plate corresponds to your local power voltage. If it does
not, consult your dealer or service organization.
3Connect the power cable to the power outlet. This switches
on the power supply. Do not connect the subwoofer to the
outlets of the receiver.
Note: To disconnect completely the subwoofer from the
power, remove the power plug from the power outlet.
The subwoofer must be adjusted to your listening
environment and to your speaker setup. This only needs to be
done once.
1Press yto switch on the subwoofer.
yThe status light turns green.
2Play one of your favorite tracks at a normal listening level.
3Turn SUBWOOFERLEVEL CONTROL to adjust the volume of
the subwoofer.
4Select the reproduced frequency range by turning
CUTOFF FREQUENCY. The higher the cut off frequency is
set, the stronger the bass reproduction will be.
Note: The subwoofer reproduces the range between 35 Hz
and the frequency selected with CUTOFF FREQUENCY.
5You may switch PHASESELECTOR from 0°to 180°. Select
the setting that provides the sound that produces the bass
effect.
6Press yto switch the subwoofer to standby.
yThe status light turns red.
1Press yto switch on the subwoofer.
yThe status light turns green.
2If the sound reproduction is noisy, reduce the volume of the
subwoofer.
3Press yto switch the subwoofer to standby.
yThe status light turns red.

Operation

Adjustment

Connections

Connectors

Controls

SPEAKER
OUT
IN
+
+
+
+
-
-
-
-
LL
RR
LL
RR
AC
MAINS
~
SOURCE
SELECTOR
SPEAKER IN / WIRELESS
SUBWOOFER IN
SUBWOOFER IN
PHASE SELECTOR
0°
180°
CUT OFF FREQUENCY
60 Hz
150 Hz
S
U
B
W
O
O
F
E
R
L
E
V
E
L
C
O
N
T
R
O
L
STANDBY - ON
MIN
MAX
HIGHPOWERSUBWOOFER
1
2
3
4
5
6
7
8
9
0