Philips Network Adaper owner manual Transmitter Control

Net 1Card IB 2/15/00 12:18 PM Page 22

RECEIVER CONTROL

RCVR SET ID allows you assign a specific number to a Net1Card Receiver TV. Each Receiver TV in the Net1Card network should have a Set ID. This allows the Transmitter TV to send a specific message this TV. It also allows the Transmitter TV to check to make sure the TV

is hooked to the network (more later). You can select a number between 0 and 32,767.

BEGIN

If not already in the “RECEIVER CONTROL” menu, press the D button on the remote control. Then press the ▼ button to highlight “RCVR SET ID.”

Press the Number buttons 0 - 9 (or the + or - but- ton) to select a Receiver ID for the TV. To set a TV with a single-digit number, press one number. For example, for 9 press the Number button 9. For a two-digit number, press two numbers. For 14, press the Number button 1, then the 4 button.

When finished, press the ▼ button to highlight “EXIT.” Then press the “M” button. Or you can exit by simply pressing the RECALL button when you’re done.

RECEIVER CONTROL

RCVR GROUP IDS	– – – – – –
RCVR SET ID	0
EXIT MENU

+/– OR DIGITS TO CHANGE

22

TRANSMITTER CONTROL

Once you have completed your general selections under the Commercial Settings menu, you must

make specific selections. If you selected “TRANSMIT” (See page 19.), follow the directions below.

BEGIN

If not already in the “TRANSMITTER CON- TROL” menu, press the D button on the remote control. “ADDRESS TYPE” should be highlighted. Address Type allows you to select which TV(s) your message will be sent to. That way, you can send a message only to one TV (“SET”), a group or groups of TVs (“GROUP”), or all the TVs (“BROADCAST”) in the Net1Card network.

Press the – (◀) or + (♣) button to select “BROAD-

CAST,” “GROUP,”or “SET.”

Next, press the ▼ button to highlight “GROUP IDS.” If you selected “BROADCAST” from “ADDRESS TYPE,” “ALL SETS” appears beside “BROADCAST” on the next line and you go on to “RCVR POWER.”

If you selected “GROUP,” use the remote control’s Number buttons 1 - 8 to select one or more groups to send your message to. To remove a group selection, press that Number button again. (Note: more than one group can be selected.)

If you selected “SET,” use the Number buttons 0 - 9 to select the individual TV to send your message to. For 136, press 1, 3, then 6.

When finished, press the ▼ button to highlight “RCVR POWER.”

TRANSMITTER CONTROL
ADDRESS TYPE		BROADCAST
BROADCAST		ALL SETS
RCVR POWER		CURRENT
RCVR VOLUME		TRANSMITTER			CONTROL
RCVR CHANNELADDRESS TYPE					GROUP
RCVR LOCKOUTGROUP IDS			– – – – – – – –
UPDATE RCVRRCVR POWER
					TRANSMITTER	CONTROL
EXIT MENU	RCVR VOLUME
PRESS	RCVR CHANNEL			ADDRESS TYPE			SET
	RCVR LOCKOUT			SET ID			0
	UPDATE RCVR		RCVR POWER				CURRENT
			RCVR VOLUME				CURRENT

23