Philips PDCC-JH-0811 user manual Pal, Ntsc, Multi, To remove the menu Press System Menu

Getting Started

1In disc mode, press SYSTEM MENU.

2Press à / á / 4 / 3 keys on the remote control to navigate in the menu.

➜Move to “Video Setup Page”and press 4.

➜Move to “TV TYPE” and press á.

PAL

–Select this if the connected TV set is PAL system. It will change the video signal of an NTSC disc and output to PAL format.

NTSC

–Select this if the connected TV set is NTSC system. It will change the video signal of a PAL video disc and output to NTSC system.

MULTI

–Select this if the connected TV set is compatible with both NTSC and PAL (multi system).The output format will be consistent wit the video signal of the disc.

3Select an item and press OK.

➜ The screen messages for further setting confirmation may appear. Follow the on-screen instructions to proceed to confirm the setting or not.

To remove the menu

Press SYSTEM MENU.

Setting up Progressive Scan feature (for

Progressive Scan TV only)

The progressive scan display twice the number of frames per seconds than interlaced scanning (ordinary normal TV system).With nearly double the number of lines, progressive scan offers higher picture resolution and quality.

IMPORTANT!

Before enabling the progressive scan feature, you must ensure:

1)Your TV can accept progressive signals, a progressive scan TV is required.

2)You have connected the DVD player to your TV using Y Pb Pr (see “Connecting TV set”)

3)Make sure Component has been set to YUV.

1Turn on your TV.

2Turn off your TV progressive scan mode or turn on interlaced mode (refer to your TV user manual).

3Press STANDBY-ONBto turn on the DVD player.

4Select the correct Video Input channel.

5In disc mode, press SYSTEM MENU.

6Press à / á / 4 / 3 keys on the remote control to navigate in the menu.

➜Move to “Video Setup Page”and press 4.

➜Move to “Progressive”>”On” and press OK.

There will be a distorted picture on your TV at this state until you turn on the progressive scan mode on your TV.

7Turn on your TV progressive scan mode (refer to your TV user manual).

8In the confirmation menu, press à / á to highlight OK in the menu and press OK on the remote to confirm.

➜Progressive scan is now set on.

➜If distorted picture still appears, it indicates

that your TV doesn’t support progressive scan. In this case, turn off progressive scan as described in “To deactivate Progressive manually”.

9Press SYSTEM MENU on the remote to exit the system menu.

➜ The setup is complete now and you can start enjoying the high quality picture.

English

17