General Information

Place the system in a location with adequate ventilation to prevent internal heat build-up in your system. Allow at least 10 cm (4 inches) clearance from the rear and the top of the unit and 5 cm (2 inches) from each side.

The ventilation should not be impeded by covering the ventilation openings with items, such as newspapers, table-cloths, curtains, etc.

Do not expose the system, batteries or discs to excessive moisture, rain, sand or heat sources caused by heating equipment or direct sunlight.

No naked flame sources, such as lighted candles, should be placed on the apparatus.

No objects filled with liquids, such as vases, shall be placed on the apparatus.

If the system is brought directly from a cold to a warm location, or is placed in a very damp room, moisture may condense on the lens of the disc unit inside the system. Should this occur, the CD player would not operate normally. Leave the power on for about one hour with no disc in the system until normal playback is possible.

The mechanical parts of the set contain self- lubricating bearings and must not be oiled or lubricated.

Batteries (battery pack or batteries installed) shall not be exposed to excessive heat such as sunshine, fire or the like.

When the system is switched to Standby mode, it is still consuming some power. To disconnect the system from the power supply completely, remove the AC power plug from the wall socket.

Maintenance

When a disc becomes dirty,

clean it with a cleaning cloth. Wipe the disc from the center out, in a straight line.

Do not expose the player, batteries or discs to humidity,

rain, sand or excessive heat

(caused by heating equipment or direct sunlight). Always keep the disc tray closed to avoid dust on the lens.

Do not use solvents such as benzene, thinner, commercially available cleaners, or anti-static spray intended for colour discs.

The lens may cloud over when the player is suddenly moved from cold to warm surroundings, making it impossible to play a disc.

Leave the player in the warm environment until the moisture evaporates.

Hearing Safety

Listen at a moderate volume.

Using headphones at a high volume can impair your hearing. This product can produce sounds in decibel ranges that may cause hearing loss for a normal person, even for exposure less than a minute. The higher decibel ranges are offered for those that may have already experienced some hearing loss.

Sound can be deceiving. Over time your hearing "comfort level" adapts to higher volumes of sound. So after prolonged listening, what sounds "normal" can actually be loud and harmful to your hearing. To guard against this, set your volume to a safe level before your hearing adapts and leave it there.

To establish a safe volume level:

Set your volume control at a low setting.

Slowly increase the sound until you can hear it comfortably and clearly, without distortion.

Listen for reasonable periods of time:

Prolonged exposure to sound, even at normally "safe" levels, can also cause hearing loss.

Be sure to use your equipment reasonably and take appropriate breaks.

Be sure to observe the following guidelines when using your headphones.

Listen at reasonable volumes for reasonable periods of time.

Be careful not to adjust the volume as your hearing adapts.

Do not turn up the volume so high that you can't hear what's around you.

You should use caution or temporarily discontinue use in potentially hazardous situations.

Do not use headphones while operating a motorized vehicle, cycling, skateboarding, etc.; it may create a traffic hazard and is illegal in many areas.

English

9

Page 9
Image 9
Philips PDCC-ZYL-0906 Maintenance, Hearing Safety, Listen at a moderate volume, To establish a safe volume level