1 General Safety Information
Do not make any changes or settings that are not described in this user manual. Physical injury or damage to the device or loss of data can result from improper handling. Take note of all warning and safety notes indi- cated.
Under the following conditions, a layer of moisture can appear inside the device which can lead to malfunctions:
·if the device is moved from a cold to a warm area;
·after a cold room is heated;
·when this device is placed in a damp room.
Proceed as follows to avoid any moisture
Setting Up the Device
The device is exclusively for indoor use. The device should be placed securely on a stable, at surface. Posi- tion all cables in such a way that no one will stumble on them, thus avoiding possible injuries to persons or dam- age to the device itself.
Do not plug in the device in moist rooms. Never touch the electrical cable or the electrical connection with wet hands.
The device must have sufcient ventilation and may not be covered. Do not put your device in closed cabinets or boxes.
Do not place the machine on soft surfaces such as table- cloths or carpets and do not cover the ventilation slits. Otherwise the device could overheat or catch re.
Protect the device against direct sunlight, heat, large temperature uctuations and moisture. Do not place the device in the vicinity of heaters or air conditioners. Observe the information on temperature and humidity in the technical data.
When the device is running for a long period of time, the surface becomes hot and a warning symbol appears on the projection. The device switches automatically to
Do not allow liquids to enter into the device. Switch off the device and disconnect it from the power supply if liquids or foreign substances end up inside the device. Have the product inspected by a technical service department.
Always handle the product with care. Avoid touching the lens. Never place heavy or sharp objects on the pro- jector or the power cable.
If the projector gets too hot or emits smoke, shut it down immediately and unplug the power cable. Have your device examined by trained professionals at a tech- nical service location. To prevent the spread of re, open ames should be kept away from the device.
1Seal this device in a plastic bag before moving it to another room, in order for it to adapt to room con- ditions.
2Wait one to two hours before you take the device out of the plastic bag.
The device should not be used in a very dusty environ- ment. Dust particles and other foreign objects may damage the product.
Do not expose the device to extreme vibrations. It may damage the internal components.
Do not allow children to handle the device without supervision. The packing materials should be kept out of the hands of children.
Repairs
Do not make any repairs to the device yourself. Improper maintenance can result in injuries or damage to the device. Have your device repaired only by an authorised service center.
Do not remove the type label from your device; this would void the warranty.
Power Supply
Use only the enclosed power adapter (see chapter Appen- dix / Technical Data). Check whether the electrical voltage of the power supply matches the electrical voltage available at the setup location. This equipment complies with the voltage type specied on the product.
The AC main plug of adaptor is used as the power discon- nect device, the
The product should be supplied by a power system com- pliant with LPS requirements of 2.5 of
The capacity of the battery diminishes with time. If the device functions only with the power supply, the battery is defective. Contact an authorised service center to replace the battery.
Do not try to replace the battery yourself. Incorrect handling of the battery or using the wrong type of bat- tery can cause damage to the device or cause injury.
Batteries (battery pack or batteries installed) must not be exposed to ame or excessive heat including from direct sunshine or the like.
Attention should be drawn to the environment aspects of battery disposal.
4 | Philips · PPX3407 · PPX3410 |
