3 Initial Operation
Setting up the Device
You can position the device so that it lies at on a table in front of the projection surface; it is not necessary to tilt it towards the projection surface. The device com- pensates for the distortion from the slanted projection (pincushion distortion).
A tripod accessory is available if you want to elevate the device (Pico Tripod / 253521272).
Connecting power supply / Charging battery
CAUTION!
Electrical Voltage at the Site of Installa- tion!
Check whether the electrical voltage of the power supply matches the electrical voltage available at the setup location.
1Insert the small plug of the power supply into the socket on the rear side of your device.
2Plug the power supply into the power outlet.
3During the charging process, the indicator light on the side of the device will be red. When the battery is fully charged, it will turn green.
4Charge the
Initial Installation
1Switch the device on using the on/off switch on the side.
2Turn the device towards a suitable projection sur- face or wall. Note that the distance to the projection surface must be a minimum of 0.5 meters and a max- imum of 5 meters. Make sure the projector is in a secure position.
3Use the focus wheel on the top to adjust the image sharpness.
4Select the desired menu language using .
5Conrm with à.
Note
The main menu appears instead of the language selection
The device has already been installed. In order to change the menu language, pro- ceed as follows:
1Use the navigation keys to select Set- tings.
2Conrm with à.
3Select with Language.
4 Conrm with à.
5 Select the desired language with .
6 Conrm with à.
7 Exit with .
Initial Operation | 9 |