Philips QT4085 manual Troubleshooting, Is the hair-collection chamber or the filter wet?

ENGLISH 13

Troubleshooting

The red light. starts blinking but the motor does not start running when the on/off button is pressed.

1If the battery is completely empty, the red battery-low light. starts blinking but the motor will not start running when you try to switch the trimmer on. Charge the appliance until it is fully charged (see chapter 'Charging').

If the suction system of the vacuum beard trimmer performs poorly or does not work at all, check the points listed below.

2Is the hair-collection chamber empty?

BWe advise you to empty the hair-collection chamber after each trimming session. When cutting long, dense beards, it may also be necessary to empty the hair-collection chamber during the trimming session.

3Is the hair-collection chamber or the filter wet?

BBoth parts may only be cleaned dry. If these parts become wet, dry them carefully.

4Does the flexible hair guide in front of the cutting unit jam?

BThe transparent hair guide needs to be flexible in order to be able to adjust to the contours of the face. If it jams because hairs have got stuck in it, remove the hairs carefully with the brush supplied.The flexible hair guide should yield at the touch of a finger.

5Do you move the appliance in the optimal direction? (fig. 8).

BFor the best possible trimming and suction performance, we advise you to move the trimmer upwards, against the direction of hair growth, making smooth and gentle strokes.