Microphone mixing

26

Microphone mixing

\For\Southeast\Asia]

Enjoy microphone mixing from various music sources such as cassette, disc, radio or portable audio equipment.

Preparation:

≥Lower the microphone volume with [jMIC VOLi] on the main unit, then connect the microphone(s) to the microphone jack(s).

Every time you press the [jMIC VOLi] buttons: MIC 1 ,. MIC 2 ,. MIC 3 ,. MIC 4

Use a dynamic microphone. Plug type: Φ6.3 mm monaural.

≥If a strange noise (howling) is emitted during use, move the

microphone away from the speakers, or lower the microphone volume.

≥When you are not using the microphone, disconnect it from the microphone jack, and lower the microphone volume to “MIC 1”.

1 Select the music source: ≥When singing along with discs

Insert the desired disc (l page 12). ≥When singing along with cassette tape

Press deck 1 [<, OPEN] on the main unit and insert the desired cassette tape (l page 25).

≥When singing along with radio Select your desired station (l page 24).≥When singing along with a portable audio equipment

Connect and prepare the portable audio equipment (l page 29).

2 Start singing and adjust volume with [jVOLUMEi] and [jMIC VOLi] on the main unit.

Record microphone mixing

\For\Southeast\Asia]

Preparation:

≥Do the preparatory steps 1 and 2 on page 25, Recording.

1 Press deck 2 [OPEN, <] on the main unit and insert a cassette tape.2 Select the music source (l see above) and press [∫].3 Press [¥, RECORD] on the main unit and start microphone mixing.

To stop recording

Press [∫].

RQTV0141

To record your voice

\For\Southeast\Asia]

Preparation:

≥Do the preparatory steps 1 and 2 on page 25, Recording. ≥Ensure that there is no tape in deck 1.

1 Press deck 2 [OPEN, <] on the main unit and insert a cassette tape.

2 Press [¥, RECORD] on the main unit to start recording.

3 Speak through the microphone and adjust volume with [jVOLUMEi] and [jMIC VOLi] on the main unit.

Adjusting the echo effect

\For\Southeast\Asia]

1 Press and hold [jECHO].

Current setting appears on the display.

2 While current setting is displayed Press [jECHO] to change the setting. Every time you press the button:

ECHO 1 ) ECHO 2 ) ECHO 3 ) ECHO 4

^---------------

ECHO OFF (off) !---------------

}

[Note]

≥The effect increases with the level.

≥The setting will change only if you press [jECHO] right after the current setting is displayed.