Positioning / The remote control

Simple setup

STEP 2 Positioning

Caution

Use the supplied speakers only with the recommended system. Failure to do so may lead to damage to the amplifier and/or the speakers, and may result in the risk of fire. Consult a qualified service person if damage has occurred or if you experience a sudden change in performance.

Using other speakers can damage the unit and sound quality will be negatively affected. Do not attach these speakers to walls or ceilings.

Positioning for best effect

1You cannot take the front net off the speakers.

2Set the speakers up on an even surface to prevent them from

5

 

falling. Take proper precautions to prevent the speakers from

 

 

falling if you cannot set them up on an even surface.

 

 

3 Placing speakers too close to floors, walls, and corners can

 

 

result in excessive bass.

4

 

4 Cover walls and windows with a thick curtain.

 

 

5 Keep your speakers at least 10 mm away from the system for

1

 

proper ventilation.

3

6 Place the subwoofer on the floor or a sturdy shelf so that it

 

2

 

would not cause vibration. Leave 10 cm at the rear for

6

 

ventilation.

 

 

Notes on speaker use

You can damage your speakers and shorten their useful life if you play sound at high levels over extended periods.

Reduce the volume in the following cases to avoid damage.

When playing distorted sound.

When the speakers emit strange noise (howling) from a microphone or record player, noise from FM broadcasts, or continuous signals from an oscillator, test disc, or electronic instrument.

When adjusting the sound quality.

When turning the unit on or off.

If irregular colouring occurs on your television

These speakers are designed to be used close to a television, but the picture may be affected with some televisions and set-up combinations.

If this occurs, turn the television off for about 30 minutes The television’s demagnetizing function should correct the problem. If it persists, move the speakers further away from the television.

STEP 3 The remote control

Remote controlBatteries

2

Insert so the poles (i and j) match those in

the remote control.

 

 

3

 

Do not use rechargeable type batteries.

1

R6/LR6, AA
Do not:

Mix old and new batteries.

Use different types at the same time.

Heat or expose to flame.

Take apart or short circuit.

Attempt to recharge alkaline or manganese batteries.

Use batteries if the covering has been peeled off. Mishandling of batteries can cause electrolyte leakage which can damage items the fluid contacts and may cause a fire.

Remove if the remote control is not going to be used for a long period of time. Store in a cool, dark place.

Use

Aim at the remote control signal sensor, avoiding obstacles, at a maximum range of 7 m directly in front of the unit.

6

RQTV0141