Philips SC2001/01 user manual English

English 17

4

,,

5

6

Press the % button to increase the intensity.To lower the intensity, press the ^button.

Every time you press the button, the corresponding intensity light starts to flash.This takes a few seconds.

Place the appliance in a 90° angle on the skin so that the attachment and the safety ring are in contact with the skin.

Press the safety ring fully onto the skin with slight pressure.

Note:The safety ring has contact switches that together are the safety system of the appliance.This safety ring prevents unintentional flashing without skin contact.

,, The ‘ready to flash’ light on the back of the appliance lights up green when all contact switches of the safety ring are in contact with the skin and the appliance is charged. This may take up to 3.5 seconds.

Tip: For easier use, stretch the area of skin you want to treat. On areas with softer skin, you may need to exert more pressure on the appliance to push in all contact switches.

7Press the flash button to release a flash.

Note:The visible light produced by the appliance is the reflection of the flash on the skin and is harmless to your eyes. It is not necessary to wear goggles during use.

8Let go of the flash button after the appliance has flashed.

9For the next flash, repeat steps 6 to 9.After each flash it takes up to 3.5 seconds until the appliance is ready to flash again.

Do not treat exactly the same area multiple times during one session. This does not improve the effectiveness of the treatment, but increases the risk of skin reactions.