Philips SC469 Using your baby monitor in Dial-up mode, Setting the Baby Unit to Dial-up mode

12ENGLISH

Using your baby monitor in Dial-up mode

Setting the Baby Unit to Dial-up mode

1 Ensure all connections have been properly made (see ‘Installing the Baby Unit’) and that at least one call-up phone number has been stored in the unit’s memory (see ‘Installing the Baby Unit for use in Dial-up mode).

2 Press the Power button (7) to switch on the Baby Unit. > The power light (8) lights up green.

3 Use the MODE button (10) to select Dial-up mode ( ).

4 Use the M(emory) button (1) to select the required call-up number (‘M1’-’M5’).

> The call-up number has now been set.

When noise is detected during your absence, the Baby Unit will call this number.

5 Use the SENSITIVITY switch (3) to adjust the microphone sensitivity of the Baby Unit to the level you prefer (using your own voice as a sound reference).

Note: If lights up the unit is not (properly) connected to the telephone network.You can not select Dial-up mode, an alert beep will sound and the Baby Unit stays in regular baby monitor mode.

Answering the Dial-up monitor’s call

•Ensure the Baby Unit is switched on and set to Dial-up mode and that a call-up phone number has been stored in the unit’s memory (see ‘Installing the Baby Unit for use in Dial-up mode).

>When noise is detected after the sensitivity time has elapsed, the Baby Unit calls the selected call-up number.

>After answering the phone, you can listen to your baby. After pressing the # button on your telephone, you can talk back to your baby.

>After three minutes the Baby Unit will break off the connection.

>If you do not answer the phone the unit will hang up and then calls back after 1 minute.

>If the unit detects noise again, it will repeat the above procedure.

•Press the * key on your telephone to end the call (for tone dialling mode only).