Philips VR220/55, VR420/55 instruction manual Set Code, Confirm Setting, TV Manufacturers’ Codes

OOperating TV			●
1
❍Set Code	TV Manufacturers’ Codes
	PHILIPS	01, 02, 03
1 Press and hold TV.
	EMERSON	14
2 Press two Number buttons for the manufactur-
er’s code number of your TV, referring to the	GOLDSTAR	04
table to the right.
	GRUNDIG	24, 25
• For example, for 02, press 0 then 2.
	HITACHI	12
3 Press STOP 7, then release TV.
• The remote control can now operate the TV of the	JVC	05
selected code.
	MITSUBISHI	13, 26
2	PANASONIC	07, 17, 19, 20
❍Confirm Setting	RCA	10
Press POWER, pointing the remote control at the
	SAMSUNG	18
TV.
If the TV turns on or off, your setting is completed.	SANYO	11
If not, repeat steps above, using another code.	SHARP	16
Notes:
	SONY	09
• After replacing the batteries, you need to reset the
manufacturer’s code again.	THOMSON	21, 22, 23
• The buttons you can use to operate your TV are	TOSHIBA	08
explained on page 3.
	ZENITH	06, 15

Before Requesting Service ●

Power

No power.

Correction

•Check that the AC power cord is correctly connected to an AC outlet.

•Check that the VCR is turned on.

Recording & Playback	Correction
TV programme cannot be recorded.	• Check the connections between the VCR, the antenna
	and the TV.

•Make sure that the record tab on the back of the cassette is not removed.

Timer recording cannot be performed.

•Set the timer on-time and timer off-time correctly.

•Make sure that the VCR is turned off after setting is made.

•Timer recording may not be performed or stopped if a power interruption occurs before or during timer recording.

There is no playback picture, or the playback picture is noisy or contains streaks.

During a still or slow motion picture, the picture may contain some vertical jitter when using a TV which has an automatic vertical hold control.

If the top of your playback picture waves back and forth excessively.

During playback, “USE CLEANING CASSETTE” appears on the screen.

•Select your video channel correctly.

•Adjust the tracking slowly in either direction.

•Try to change to another tape, you may not have this problem.

•Because the VCR playback signal is not as stable as an off-the-air TV signal, the top of your TV screen may be bent or unstable during playback. You may have better result if the A/V input is used.

•The video heads are dirty. Use a head cleaner.

15