VRX240comb 4/8/99 8:45 PM Page 5

Removing the Plastic Cover from the Front Panel

A thin, plastic cover may protect the front panel of your VCR. Before using the VCR, lift a corner of the plastic, then peel it off.

Putting Batteries in the Remote Control

1

Remove the battery compartment lid on the bottom of the remote control by sliding it in the direction of the arrow.

2

Place two AA batteries inside the battery compartment

with their + and – ends aligned as indicated.

3

Replace the battery compartment lid.

Using the Remote Control

Point the remote control at the VCR’s remote sensor (see page 22) when using the remote control to operate the VCR.

Do not put objects between the remote control and the VCR.

Before Using Your VCR 5

1

2 3

Erasure Prevention

Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.

1

To prevent erasure, break off the tab with a screwdriver.

2

To record again, cover the hole with cellophane tape.

VCR maintenance

Use only tapes with the mark.

Remove any light adhesive stick-on notes from the video cas- sette tape before putting the tape in the VCR. Removable labels can jam the VCR.

Periodic maintenance is required to maintain your VCR’s excel- lent performance. This VCR has an Automatic Head Cleaner. However, the video heads will require replacement eventually. Only an authorized service center should perform this service.

1

2

Helpful Hints

Do not mix alkaline and man- ganese batteries.

Do not mix old and new batteries.

Page 5
Image 5
Philips VRX242AT owner manual Before Using Your VCR