Philips VRZ250AT Rerecording Tape Duplication, Channel the CH3/CH4 switch on VCR 2 is set to

VRZ220/250 layout 4/8/99 10:11 PM Page 32

32 Rerecording (Tape Duplication)

The instructions on this page show you how to copy tapes. The illustration uses two VRZ250 VCRs. Different VCRs may operate differently. To duplicate a tape, make the connections shown, then follow steps 1 - 7.

1.Audio cables from AUDIO OUT Jacks of VCR 1 to AUDIO IN Jacks of VCR 2

VCR 1
Playing VCR
AUDIO		ANT
		IN
	L
OUT	IN
	R
VIDEO		OUT
OUT	IN CH3	CH4

VCR 2 - Recording VCR

AUDIO		ANT
		IN
	L
OUT	IN
	R
VIDEO		OUT
OUT	IN CH3	CH4

2.Video cable from VIDEO OUT Jack of VCR 1 to VIDEO IN Jack of VCR 2

●Audio and Video cables are not supplied.

3.RF coaxial cable from VCR’s OUT Jack to TV’s

ANTENNA IN

Jack

1

Make the connections shown above.

2

VCR 1 will play your tape. Put a prerecorded tape in VCR 1.

3

VCR 2 will record your tape. Insert a blank tape in VCR 2. The VCR must be in VCR position. (The VCR/TV light will appear on the display panel. If it does not, press the VCR/TV button once.)

4

Turn on the TV and set it to channel 03 or 04, whichever

channel the CH3/CH4 switch on VCR 2 is set to.

5

Point the remote control at VCR 2. Press Number buttons 0, 0 to select Line Input. A/V IN will appear on-screen.

6

Use the SPEED button to select SP, LP, or SLP at VCR 2.

7

Press the PLAY button on VCR 1 and the REC(ord)/OTR button on VCR 2 at the same time.

To stop recording, press the STOP/EJECT button on VCR 1, then press the STOP/EJECT button on VCR 2.

Helpful Hints

•Unauthorized recording of copy- righted television programs, video tapes, or other materials may infringe on the rights of copyright owners and violate copyright laws.

•The VCR in the figure above is the VRZ250. If you have the VRZ220, use a single-plug audio cable to con- nect the AUDIO OUT Jack on VCR 1 to the AUDIO IN Jack on VCR 2.