VRZ220/250 layout 4/8/99 10:11 PM Page 5
Before Using Your VCR 5
Removing the Plastic Cover from the Front Panel
A thin, plastic cover may protect the front panel of your VCR. Before using the VCR, lift a corner of the plastic, then peel it off.
Putting Batteries in the Remote Control
1
Remove the battery compartment lid on the bottom of the remote control by sliding it in the direction of the arrow.
2
Place two AA batteries inside the battery compartment
with their + and – ends aligned as indicated.
3
Replace the battery compartment lid.
Using the Remote Control
●Point the remote control at the VCR’s remote sensor (see page 22) when using the remote control to operate the VCR.
●Do not put objects between the remote control and the VCR.
1
2 
3
Erasure Prevention
Video cassette tapes have record tabs to ensure that recordings are not accidentally erased.
1
To prevent erasure, break off the tab with a screwdriver.
2
To record again, cover the hole with cellophane tape.
VCR maintenance
●Use only tapes with the 
mark.
●Remove any light adhesive
●Periodic maintenance is required to maintain your VCR’s excel- lent performance. This VCR has an Automatic Head Cleaner. However, the video heads will require replacement eventually. Only an authorized service center should perform this service.
1
2
Helpful Hints
•Do not mix alkaline and man- ganese batteries.
•Do not mix old and new batteries.
