Philips VRZ220AT, VRZ250AT owner manual Turning on Your VCR, 2Turn on the TV

VRZ220/250 layout 4/8/99 10:11 PM Page 11

Before turning on your VCR, make sure there are batteries in the remote control and the VCR and TV are connected correctly.

●You can not program channels if you are using a Cable Box or a Direct Broadcast System.

1

Press the POWER button. The VCR/TV light and the POWER light will appear on the display panel.

2

Turn on the TV. Set it to the same channel as the CH3/CH4 switch on the back of the VCR. The display shown below will appear. (If the display does not appear, check your hookups, then follow the steps on page 12 to set up channels and page 17 to select a language.)

SELECT op
→ ENGLISH	ON
ESPAÑOL

MAKE SELECTION OR

PUSH MENU TO CONTINUE

Turning on Your VCR 11

2Turn on the TV.

1	POWER		VCR/TV	EJECT
	1	2	3		5
	4	5	6
4	7	8	9	CHANNEL
		0	+100
	SPEED	TIME SEARCH		MEMORY
	MENU	STATUS/EXIT	CLEAR	SLOW
3	REWIND	/PLAY		F.FWD
	REC/OTR	/STOP		PAUSE/STILL

3

Within 60 seconds, press the PLAY/o button or the STOP/p button to select English or Spanish on-screen displays.

4

Press the MENU button. The display shown below will appear.

CONNECT ANTENNA OR CABLE

TO VCR

THEN . . .

PUSH CH UP KEY

OR . . .

FOR PLAY ONLY – PUSH STOP

5

Within 60 seconds, press the CHANNEL o button to begin automatic channel programming. AUTO SET PRO- CEEDING PLEASE WAIT will appear on-screen. The VCR will memorize all available channels. When all channels are pro- grammed, CHANNELS ARE SET will appear on-screen briefly, then TV programming will appear.

Now, when you press the CHANNEL o/p buttons, you’ll only scan through channels that you receive.

Helpful Hints

•To skip this feature and play a tape immediately, insert a tape with its record tab removed. Or, to skip step 3, press the MENU button. All on- screen displays will be in English. To skip step 5, press the STOP/p but- ton. Channels will not be pro- grammed, and CHANNELS NOT SET will appear on-screen.

•If you try to program channels when there is no antenna or cable connected to the VCR, programming will appear to take place, but even- tually a NO TV SIGNALS message will appear. Connect an antenna or cable to the VCR’s ANT(enna) IN Jack and try again. You may need to follow the steps on page 12.

•The TIMER light on the VCR will blink when the power is restored after a power failure of more than one minute.