Phoenix Gold IAMP-GM1 installation instructions Phoenix Gold iSeries

Phoenix Gold iSeries

Step 4 - Unplug the (3) factory amplifier plugs from the factory amplifier (Fig K). Remove the factory harness from the fastening points (Fig L). This harness will need to be rerouted back toward the rear of the back seat to allow connection to the iSeries factory integration harness (Fig M). In the iSeries factory integration harness you will locate a 2 foot long harness that has a 12-pin white Molex connector on one end and a 16-pin green adaptor plug on the other end (Fig N). Plug in the green 16 pin iSeries adaptor plug to the factory harness that was routed towards the front of the vehicle. Please note that only one of the factory plugs will be used for this application.

Fig. J Fig. K Fig. L

Fig. M Fig. N

Step 5 - Reinstall the carpet leaving the harness that you connected in step 4 exposed so that you can easily plug it into the iSeries amplifier (Fig O). This harness will plug into the iSeries amplifier on the front side (located closest to the rear seat). Re-install the rear plastic panel using the (6) cargo net holders you removed in Step 2 (Fig P).

Fig. O Fig. P

5www.PHOENIXGOLD.com