Phoenix Gold iSeries
Step 6 - Connect the supplied iSeries power harness to the 12 volt and ground connection points on the iSeries amplifier (Fig Q). Route the supplied iSeries power harness toward the factory battery location. On the right rear (passenger side) of the spare tire well you will see the factory grounding point. Remove the factory bolt and connect the supplied iSeries ground wire along with the factory ground (Fig R). Make sure to tighten securely. Unclip the positive battery cover to expose the positive battery terminal. On the left (driver) side of the battery terminal remove the 10mm nut and attach the positive lead from the supplied iSeries harness (Fig S).
|
|
|
|
|
Fig. Q |
| Fig. R |
| Fig. S |
Step 7 - Route the supplied iSeries power harness along the factory power and ground leads for the battery and secure to the harness with the supplied wire ties (Fig T). Put the spare tire (if equipped), or the molded foam inflation system back into their original location (Fig U). Replace the factory spare tire well cover and secure with the factory fastener.
|
|
|
|
| |
Fig. T | |||||
| Fig. U | Fig. V |
Fig. W
