Phoenix Gold IAMP-GM1 Accessing the Battery and Factory Amplifier If equipped, Fig. B

Phoenix Gold iSeries

3.Accessing the Battery and Factory Amplifier (If equipped)

Step 1 - Remove the trunk floor liner (Fig. A) and unscrew the spare tire cover fastener (Fig. B). Remove the spare tire cover. Remove either the spare tire (if equipped), or the molded foam tire inflation kit (Fig C). This will give you access to the battery location.

	Fig. B
Fig. A		Fig. C

**If the vehicle is equipped with a factory amplifier continue to step 2. If not equipped with a factory amplifier please skip to step 6

Step 2 - Remove the (6) cargo net holders in the rear of the trunk by unscrewing them (Fig D). Remove the rear plastic panel by pulling it up and out (towards the front of the vehicle) (Fig E).

Fig. D	Fig. E
		Fig. F

Step 3 - There is a plastic push clip located on the upper section of the left (drivers side) carpet panel (Fig G) and a threaded plastic washer on the lower section that needs to be removed (Fig H). Pull back the carpet on the left (drivers side) of the trunk to gain access to the stock amplifier which is located on the back wall of the trunk (near the bumper) (Fig I & J).

	Fig. G
			Fig. H
				Fig. I
4		www.PHOENIXGOLD.com