Phoenix Gold iSeries
6. Routing the iSeries Signal Harness
Step 1 - Route the iSeries
|
|
|
Fig. A |
| Fig. B |
Step 2 - Remove the driver’s door sill, kick panel, and left side dash panel (Fig C & D). Route the iSeries harness to the rear of the car from the factory radio securing it to the factory harness along the way with the supplied wire ties (Fig E).
|
|
|
|
|
Fig. C |
| Fig. D |
| Fig. E |
Step 3 - Remove the lower section of the rear seat by lifting up on it to release the factory clips (Fig F & G). Continue to route the wires from the front of the vehicle to the trunk. PLEASE NOTE: Be sure to keep the iSeries wire harness away from the factory power lead for the battery (Fig H). Once the iSeries harness has been routed to the trunk connect it to the iSeries amplifier. ***If vehicle is not equipped with a factory amplifier the short 2 foot adaptor harness will plug into the harness coming from the factory radio***
|
|
|
|
|
|
|
|
|
| Fig. F |
|
| |||||
|
|
| Fig. G |
|
| Fig. H |
| |
9 |
| www.PHOENIXGOLD.com |
|
|