Settings of the Sound Characteristics
PIEGA P SUB 1 MKII
Setting options for individual requirements...
Thanks to the use of the most advanced active electronics, your new PIEGA P SUB 1 MKII is a cutting edge product in the field of subwoofers. Thanks to the variable „HP Filter Q“ it features the ability to simulate an unlimited range of sound characteristics. This enables you to adjust operation within the deep bass range to your individual audio requirements, as well as to those of the listening environment.
VOLUME
MIN.
MAX.
0 
180
ON 
OFF SUBSONIC
60Hz
CROSSOVER
FREQUENCY
40Hz 140Hz
VOLUME
>Use this knob to adjust the subwoofer volume
Setting tip: Turn the subwoofer to maximum volume and then turn it down until it sounds too quiet for you
PHASE-SWITCH
>Use this switch to set the subwoofer to In Phase or Out of Phase. Depending on the type of loudspeaker, there will be a phase cancelling (little bass) or a phase correction (normal bass)
>>Factory setting 0
>Use this knob to adjust the phase to your system >>Factory setting 0
SUBSONIC
>Use this selector switch to activate the SUBSONIC filter. This is used to filter out frequencies below 15 Hz and thus relieve the subwoofer of inaudible frequencies
>>Factory setting OFF
FILTER-Q
>Use this knob to set the filter quality in the range between 0.5 to 0.8 - Turning the knob clockwise will cause a dry, clean and very precise bass, turning the knob
CROSSOVER-FREQUENCY
>This knob is used for adjusting the crossover frequency between subwoofer and
>>Factory setting 80 – 100 Hz
13
