Resetting the microprocessor
PressingRESET lets you reset the micropro-
cessorto its initial settings.
Themicroprocessor must be reset under the
followingconditions:
!Priorto using this unit for the first time
afterinstallation
!Ifthe unit fails to operate properly
!Whenstrange or incorrect messages ap-
pearon the display
1 Turnthe ignition switch OFF.
2 PressRESET with a pen tip or other
pointedinstrument.
RESETbutton
Notes
!Whenusing with a Pioneer navigation unit, if
youpress RESET, be sure ACC OFF is se-
lected.If ACC ON is selected, correct opera-
tionmay not be possible even if you press
RESET.
!Aftercompleting connections or when you
wantto erase all memorized settings or return
theunit to its initial (factory) settings, switch
yourengine ON or set the ignition switch to
ACCON before pressing RESET.
Use and care of the remotecontrol

Installing the battery

Slidethe tray out on the back of the remote
controland insert the battery with the plus (+)
andminus () poles pointing in the proper di-
rection.
!Whenusing for the first time, pull out the
filmprotruding from the tray.
WARNING
Keepthe battery out of the reach ofchildren.
Shouldthe battery be swallowed, immediately
consulta doctor.
CAUTION
!Useonly one CR2025 (3 V) lithium battery.
!Removethe battery if the remote control is not
usedfor a month or longer.
!Donot recharge, disassemble, heat or dispose
ofthe battery in fire.
!Donot handle the battery with metallic tools.
!Donot store the battery with metallicmateri-
als.
!Inthe event of battery leakage, wipe the re-
motecontrol completely clean and install a
newbattery.
!Whendisposing of used batteries, please
complywith governmental regulations or en-
vironmentalpublic institutionsrules that
applyin your country/area.
Before YouStart
En
14
Section
02