Pioneer DEH-P4050UB Initial Settings Adjusting initial settings, Setting the FM tuning step

Section
04		Initial Settings
	Adjusting initial settings		4 Turn MULTI-CONTROL to put a clock
	1 Press SOURCE and hold until the unit		right.
			# You can also perform the same operations by
	turns off.
			pushing MULTI-CONTROL up or down.
	2 Press MULTI-CONTROL and hold until
	CLOCK SET appears in the display.		Setting the FM tuning step

3Turn MULTI-CONTROL to select one of the initial settings.

CLOCK SET (clock)—FM STEP (FM tuning step)—AM STEP (AM tuning step)— WARNING TONE (warning tone)—AUX1 (aux- iliary input 1)—AUX2 (auxiliary input 2)— DIMMER (dimmer)—SW CONTROL (rear out- put and subwoofer controller)—DEMO MODE (feature demo)—EVER SCROLL (ever scroll)— BT AUDIO (Bluetooth audio)—

PIN CODE INPUT (pin code input)—

BT VER INFO (Bluetooth version information)

#You can also perform the same operations by pushing MULTI-CONTROL up or down.

#You can also select the function by pressing FUNCTION on the remote control.

#To cancel initial settings, press BAND.

#BT AUDIO, PIN CODE INPUT and

BT VER INFO can be selected only when Blue- tooth adapter (e.g., CD-BTB100) is connected to this unit.

Setting the clock

Use these instructions to set the clock.

1Use MULTI-CONTROL to select

CLOCK SET.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Press MULTI-CONTROL to select the seg- ment of the clock display you wish to set. Each time you press MULTI-CONTROL, one segment of the clock display is selected. Hour—Minute

As you select segments of the clock display, the selected segment blinks.

The FM tuning step employed by seek tuning can be switched between 100 kHz, the preset step, and 50 kHz.

!If seek tuning is performed in 50 kHz steps, stations may be tuned in imprecisely. Tune in the stations with manual tuning or use seek tuning again.

1Use MULTI-CONTROL to select FM STEP.

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the FM tuning step.

Turning MULTI-CONTROL will switch the FM tuning step between 50 kHz and 100 kHz. The selected FM tuning step will appear in the dis-

play.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Note

The tuning step remains at 50 kHz during manual tuning.

Setting the AM tuning step

The AM tuning step can be switched between 9 kHz, the preset step, and 10 kHz. When using the tuner in North, Central or South America, reset the tuning step from 9 kHz (531 kHz to 1 602 kHz allowable) to 10 kHz (530 kHz to 1 640 kHz allowable).

1Use MULTI-CONTROL to select

AM STEP.

26 En