Pioneer DEH-P4050UB Switching the warning tone, Switching the dimmer setting, Initial Settings

	Section
Initial Settings	04

2Press MULTI-CONTROL to display the setting mode.

3Turn MULTI-CONTROL to select the AM tuning step.

Turning MULTI-CONTROL will switch the AM tuning step between 9 kHz and 10 kHz. The se- lected AM tuning step will appear in the dis-

play.

# You can also perform the same operations by pushing MULTI-CONTROL up or down.

Switching the warning tone

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can turn the dimmer on or off.

1Use MULTI-CONTROL to select DIMMER.

2Press MULTI-CONTROL to turn dimmer

on.

# To turn dimmer off, press MULTI-CONTROL again.

English

If the front panel is not detached from the head unit within four seconds of turning off the ignition, a warning tone sounds. You can turn off the warning tone.

1Use MULTI-CONTROL to select

WARNING TONE.

2Press MULTI-CONTROL to turn warning

tone on.

# To turn warning tone off, press MULTI-CONTROL again.

Setting the rear output and subwoofer controller

This unit’s rear output (rear speaker leads out- put) can be used for full-range speaker (FULL) or subwoofer (SUB W) connection. If you switch the rear output setting to SUB W, you can connect a rear speaker lead directly to a subwoofer without using an auxiliary amp. Initially, the unit is set for rear full-range speak- er connection (FULL).

1Use MULTI-CONTROL to select

SW CONTROL.

Switching the auxiliary setting

Auxiliary devices connected to this unit can be activated individually. Set each AUX source to ON when using. For more information about connecting or using auxiliary devices, refer to Using the AUX source on page 30.

1Use MULTI-CONTROL to select AUX1/ AUX2.

2Press MULTI-CONTROL to turn AUX1/

AUX2 on.

# To turn AUX off, press MULTI-CONTROL again.

2Press MULTI-CONTROL to display the

setting mode.

# Press BACK to return to the previous display.

3Use MULTI-CONTROL to select the de- sired setting.

Turn to change the setting.

SUB W (subwoofer)—FULL (full-range speak-

er)

# When no subwoofer is connected to the rear

output, select FULL.

# When a subwoofer is connected to the rear output, set for subwoofer SUB W.

En 27