Pioneer DEH-P80RS Initial Settings, Switching the auxiliary setting, Switching the dimmer setting

Initial Settings

#To turn the face auto open off, press MULTI-CONTROL again.

Switching the auxiliary setting

Auxiliary equipments connected to this unit can be activated individually. Set each AUX source to ON when using. About connecting or using auxiliary equipments, refer to Using the AUX source on page 68.

1Use MULTI-CONTROL to select AUX1/ AUX2.

AUX1/AUX2 appears in the display.

2Press MULTI-CONTROL to turn AUX1/ AUX2 on.

ON appears in the display.

# To turn AUX off, press MULTI-CONTROL again.

Switching the dimmer setting

To prevent the display from being too bright at night, the display is automatically dimmed when the car’s headlights are turned on. You can turn the dimmer on or off.

1Use MULTI-CONTROL to select Dimmer. Dimmer appears in the display.

2Press MULTI-CONTROL to turn dimmer

on.

ON appears in the display.

# To turn dimmer off, press MULTI-CONTROL again.

Black plate (65,1)

Section

12

1 Use MULTI-CONTROL to select	English
Brightness.
Brightness appears in the display.
2 Push MULTI-CONTROL left or right to
adjust the brightness level.
Each time MULTI-CONTROL is pushed left or
right, brightness level increases or decreases.
00 to 15 is displayed as the level is increased
or decreased.
# When dimmer is functioning, the brightness
level can be adjusted 00 to 10.

Correcting distorted sound

When listening to a CD or other source on which the recording level is high, setting the equalizer curve level to high may result in dis- tortion. You can switch the digital attenuator to low to reduce distortion.

!Sound quality is better at the high setting so this setting is usually used.

1Use MULTI-CONTROL to select Digital ATT.

Digital ATT appears in the display.

2Press MULTI-CONTROL to select the di- gital attenuator level.

Pressing MULTI-CONTROL repeatedly will

switch between High (high) and Low (low) and that status will be displayed.

Adjusting the brightness

You can adjust the display brightness. Initially this mode is set to 12.

En 65

<CRD4082-A/N>65