Pioneer DEH-P80RS operation manual Using subwoofer output, Audio Adjustments

Section

11 Audio Adjustments

Low LPF: 25—31.5—40—50—63—80—100

—125—160—200—250 (Hz)

Mid HPF: 25—31.5—40—50—63—80—100

—125—160—200—250 (Hz)

Mid LPF: 1.25k—1.6k—2k—2.5k—3.15k— 4k—5k—6.3k—8k—10k—12.5k (Hz) HighHPF: 1.25k—1.6k—2k—2.5k—3.15k— 4k—5k—6.3k—8k—10k—12.5k (Hz)

5Push MULTI-CONTROL up or down to adjust the level of the selected speaker unit (filter).

Each time MULTI-CONTROL is pushed up or down, the level of the selected speaker unit (fil- ter) increases or decreases.

±0dB to –24dB is displayed as the level is in- creased or decreased.

+6dB to –24dB is displayed as the level is in- creased or decreased, only if you have se- lected Low LPF.

6Turn MULTI-CONTROL to select NW 3. NW 3 appears in the display.

7Push MULTI-CONTROL left or right to select the slope of the selected speaker unit (filter).

Each time MULTI-CONTROL is pushed left or right, slopes are selected in the following order:

Low LPF: –36— –30— –24— –18— –12 (dB/ oct.)

Mid HPF: –24— –18— –12— –6—Pass (0) (dB/oct.)

Mid LPF: –24— –18— –12— –6—Pass (0) (dB/oct.)

HighHPF: –24— –18— –12— –6 (dB/oct.)

8Push MULTI-CONTROL up or down to switch the phase of the selected speaker unit (filter).

Push MULTI-CONTROL up selects normal phase and NOR appears in the display. Push MULTI-CONTROL down selects reverse phase and REV appears in the display.

54 En

Black plate (54,1)

#You can adjust the parameters for other speaker units (filters) in the same way.

9Turn MULTI-CONTROL to select NW 4. NW 4 appears in the display.

10Push MULTI-CONTROL left or right to select stereo or monaural.

Push MULTI-CONTROL left to select monaural and MONO appears in the display. Push MULTI-CONTROL right to select stereo and

Stereo appears in the display.

# You can operate this procedure only when Low LPF is selected.

11Press BAND to cancel the network ad- justment mode.

Using subwoofer output

Using subwoofer output

This unit is equipped with a subwoofer output which can be turned on or off. When a sub- woofer is connected to this unit, turn the sub- woofer output on.

The subwoofer output phase can be switched between normal and reverse.

1Use MULTI-CONTROL to select SW 1. SW 1 appears in the display.

2Press MULTI-CONTROL to turn subwoo- fer output on.

ON appears in the display. Subwoofer output

is now on.

# To turn subwoofer output off, press MULTI-CONTROL again.

<CRD4082-A/N>54