[SND/RTN]

 

 

[1/7

]

 

[2/7

]

 

 

 

[3/7

]

 

 

 

 

 

[7/7

 

 

 

 

 

 

 

]

 

 

[6/7

 

 

 

 

 

 

 

]

 

[5/7

]

 

 

[4/7

]

3 Press the [BEAT c, d] button.

Set the MIDI signal’s waveform output time.

4Press the [ON/OFF] button of [BEAT EFFECTS] or touch the [X-PAD].

The MIDI message for turning the effect on is sent.

!When the [LFO FORM (WAKE UP)] button is pressed and a setting from

[1/7] – [7/7] is selected, the MIDI message for the buttons and con- trols below can be sent even when the MIDI mode is turned off.

—[X-PAD] (Touch n Release)

—[CUE] button of [BEAT EFFECTS]

—Effect channel selector switch

—[LEVEL/DEPTH] control

—[ON/OFF] button of [BEAT EFFECTS]

!When the [LFO FORM (WAKE UP)] button is pressed to switch between [SND/RTN] and [MIDI LFO], BEAT EFFECT automatically turns off.

!It is not possible to switch between [SND/RTN] and [MIDI LFO] while touching the [X-PAD].

Sending the MIDI start and MIDI stop messages

Press the [START/STOP] button for [MIDI].

!The MIDI start and MIDI stop messages are sent alternatively each time the

[START/STOP] button is pressed, regardless of whether the MIDI function is on or off.

Operating an external MIDI sequencer

This unit outputs the operation information of buttons and controls in universal MIDI format.

This unit sends the tempo of the currently playing source (BPM information) as the MIDI timing clock. This can be used to synchronize an external MIDI sequencer with the tempo of the source.

!For the messages output by this unit, see MIDI assignment map on page 22.

!External MIDI sequencers not supporting MIDI timing clocks cannot be synchronized.

!External MIDI sequencers cannot be synchronized for sources for which the BPM cannot be measured stably.

!The MIDI timing clock is output even with BPM values input manually by tapping the [TAP] button with a finger. The MIDI timing clock output range is 40 BPM to 250 BPM.

1Connect the [MIDI OUT] terminal to the external MIDI sequencer’s MIDI IN terminal using a commercially available MIDI cable.

2Set the external MIDI sequencer’s sync mode to Slave.

3Press the [START/STOP] button for [MIDI].

The MIDI start message is sent.

4 Press [ON/OFF] in the [MIDI] section.

Transmission of the MIDI messages begin.

18En