Click the [MIXER INPUT] tab.
Setting the audio data output from this unit to the computer
When Serato DJ is running and using this unit as the default audio device, set the audio data output in Serato DJ.
Display the setting utility before starting.
1 Click the [MIXER OUTPUT] tab.
Adjusting the buffer size (when using Windows ASIO)
If an application using this unit as the default audio device (DJ software, etc.) is run- ning, quit that application before adjusting the buffer size.
Display the setting utility before starting.
Click the [ASIO] tab.
!If the buffer size is made large, drops in audio data (breaks in the sound) occur less easily, but the time lag due to the delay in the transfer of the audio data (latency) increases.
settings the Changing
2 Click the [Mixer Audio Output]
Select and set the audio data to be output to the computer from the flow of audio signals inside this unit.
CH1 | CH2 | CH3 | CH4 | |
CH1 Control Tone | CH2 Control Tone | CH3 Control Tone | CH4 Control Tone | |
PHONO1 | PHONO1 | PHONO1 | PHONO1 | |
CH1 Control Tone | CH2 Control Tone | CH3 Control Tone | CH4 Control Tone | |
CD/LINE1 | CD/LINE1 | CD/LINE1 | CD/LINE1 | |
CH1 Control Tone | CH2 Control Tone | CH3 Control Tone | CH4 Control Tone | |
DIGITAL1 | DIGITAL1 | DIGITAL1 | DIGITAL1 | |
Post CH1 Fader2 | Post CH2 Fader2 | Post CH3 Fader2 | Post CH4 Fader2 | |
Cross Fader A2 | Cross Fader A2 | Cross Fader A2 | Cross Fader A2 | |
Cross Fader B2 | Cross Fader B2 | Cross Fader B2 | Cross Fader B2 | |
MIC | MIC | MIC | MIC | |
MIX (REC OUT)2 | MIX (REC OUT)2 | MIX (REC OUT)2 | MIX (REC OUT)2 |
1The audio data is output with the same volume at which it is input to this unit, regardless of the [USB Output Level] setting.
2When using for applications other than recording, pay attention to the DJ application’s set- tings so that no audio loops are generated. If audio loops are generated, sound may be input or output at unintended volumes.
3Click the [USB Output Level]
Adjust the volume of the audio data output from this unit.
!The [USB Output Level] setting is applied equally to all audio data. However, when 1 on the table at step 2 is selected, the audio data is output with the same volume at which it is input to this unit.
!If not enough volume can be achieved with the DJ software’s volume adjustment alone, change the [USB Output Level] setting to adjust the volume of the audio data output from this unit. Note that the sound will be distorted if the volume is raised too high.
Checking the version of the driver software
Display the setting utility before starting.
Click the [About] tab.
Checking the latest information on the driver software
For the latest information on the driver software for exclusive use with this unit, visit our website shown below.
http://pioneerdj.com/support/
!Operation cannot be guaranteed when multiple units of this mixer are con- nected to a single computer.
En 25