Pioneer DV-48AV Additional information Troubleshooting, Problem, Remedy, Settings are canceled

09Additional information

Troubleshooting

Incorrect operation is often mistaken for trouble or malfunction. If you think that there is something wrong with this component, check the points below. Sometimes the trouble may lie in another component. Inspect the other components and electrical appliances being used. If the trouble cannot be rectified after checking the items below, ask your nearest Pioneer authorized service center or your dealer to carry out repair work.

Problem

The disc won’t play or is automatically ejected after loading.

Remedy

•Make sure the disc is free from dirt and dust and is not damaged (page 51).

•Make sure the disc is loaded with the label side face-up and aligned properly in the disc tray guide.

•Incompatible region number: If the region number on a DVD-Video disc does not match the number on the player, the disc cannot be used (page 53). In this case the attention sentence “Incompatible disc region number Can’t play disc” is displayed on screen.

•Condensation inside the player: Allow time for condensation to evaporate. Avoid using the player near an air-conditioning unit.

•Disc is loaded upside down: Reload the disc with the label side face up.

DVD-Audio playback • The disc may have been illegally copied. stops.

Picture playback stops and the operation buttons cannot be used.

•Press , then start playback again ().

•Press and hold the front panel  STANDBY/ON button for about 10 seconds to switch the unit off, then press again to switch back on.

•Switch the power off once, unplug from the wall socket, then plug back in and switch on again using the front panel  STANDBY/ON button.

New settings made in the • Some settings can be changed while a disc is playing, but are not Setup screen menus while effective until the disc is stopped then restarted: Press , then start

a disc is playing are playback again (). ineffective.

Settings are canceled.	• When the power is cut due to power failure or by unplugging the
	power cord, settings will be canceled: Press  STANDBY/ON on the
	front panel to turn the player off. Wait for -OFF-to disappear from the
	display, then unplug the power cord.
The remote control	• The remote control is too far from the player, or the angle with the
doesn’t seem to work.	remote sensor is too wide: Use the remote within its operating range
	(page 19).
	• The batteries are exhausted: Put in new ones (page 7).

54

En