09Additional information
Problem | Remedy |
Cannot play multi- | • Make sure that Audio Output Mode is set to 5.1 Channel |
channel audio. | (page 45). |
| • Check that the Dolby Digital, DTS and MPEG Out settings (page 39) |
| are suitable for your amplifier/receiver — check the instruction manual |
| that came with your amplifier/receiver. |
| • |
| Listen through the player’s analog outputs. |
| • Check that the settings in the Speaker Installation screen are correct |
| (page 50). |
| • Check the audio options available from the disc menu. |
Cannot listen to high- sampling rate audio through the digital output.
•Make sure that Linear PCM Out is set to Down Sample Off (page 39).
•As a
Cannot output 192 kHz or | • The player does not output digital audio at these sampling rates. The |
176.4 kHz digital audio. | digital output is automatically downsampled. |
Cannot output 96 kHz or • Check that Linear PCM Out is set to Down Sample Off (page 39).
88.2kHz digital audio. • Some discs are digital copy protected and do not output high sampling rate digital audio. In this case the output is automatically downsampled.
No DTS audio output. • If this unit is connected to a
•If this unit is connected to a
Audio mix does not sound right or sounds incomplete (for example, inaudible dialog).
•Make sure that Audio Output Mode is set to 2 Channel if you’ve connected to the stereo inputs on your amplifier or TV (page 45).
Can’t hear effect of | • Virtual Surround does not work with SACD or |
Virtual Surround. | • The Virtual Surround effect is only output through the AUDIO OUT |
| (2ch) analog audio outputs. |
| • Make sure that Audio Output Mode is set to 2 Channel (page 45). |
| • The effectiveness of Virtual Surround varies with the disc. |
|
|
56
En