15Additional information

Message

Searching for printer. Please wait a moment.

The printer is not ready or there is no printer connected. Please check the printer status.

Printing has been canceled because ...

Explanation/Action

This message is displayed when the recorder is scanning for a connected printer, or when the printer is not yet ready for printing. If there is no printer connected, please connect one.

If the message does not disappear, try disconnecting then reconnecting the USB cable. (Note that this recorder may not work correctly with all printers.)

This message is displayed when communication could not be established with the printer. See the Troubleshooting section if you do not know the cause.

This message is displayed when there is a printer error during printing. After checking the printer for the cause of the error, either reconnect the printer and start the printing job again, or select "Yes" to resume printing (select "No" to cancel the print job). See also the operating instructions that came with your printer for possible causes of print errors.

About DV

DVR-640H-S/DVR-541H-S only

Using DV, also known as i.LINK or IEEE 1394- 1995, you can connect a DV camcorder to this recorder using a DV cable for input of audio, video, data and control signals.

“i.LINK” and the “i.LINK” logo are trademarks.

This recorder is only compatible with DV- format (DVC-SD) camcorders. Digital satellite receivers and Digital VHS video recorders are not compatible.

You cannot connect more than one DV camcorder at a time to this recorder.

You cannot control this recorder from external equipment connected via the DV IN jack.

It may not always be possible to control the connected camcorder via the DV IN jack.

Digital camcorders can usually record audio as stereo 16-bit / 48 kHz, or twin stereo tracks of 12-bit / 32 kHz. This recorder can only record one stereo audio track. Set the DV Input setting as required (see DV Input on page 113).

Audio input to the DV IN jack should be 32 kHz or 48 kHz (not 44.1 kHz).

Picture disturbance in the recording may occur if the source component pauses playback or plays an unrecorded section of tape, or if the power fails in the source component, or the DV cable is disconnected.

The DV IN jack is an input only. There is no output functionality.

130

En

Page 130
Image 130
Pioneer operating instructions About DV, DVR-640H-S/DVR-541H-S only