About trademarks and registered trademarks, Output Routing

8.When "Finish" is displayed in the lower right corner of the wizard, click "Finish" to complete the Setup Wizard.

9.Select [File] > [Controller Manger...]. Under [Device Setup], select the [PIONEER_DDJ-ERGO] from [Device] menu and select the device corresponding to the DDJ-ERGO at [In-Port] and [Out-Port].

(2)Output Routing

・Mixing Mode：INTERNAL ・Output Monitor：

L 3:DDJ-ERGO PHONE L

R 4:DDJ-ERGO PHONE R

・Output Master：

L 1:DDJ-ERGO MASTER L R 2:DDJ-ERGO MASTER R

(3) Input Routing

*For those who do not use external input (AUX/MIC), the following setup is not needed.

・Input Aux

L(Mono) 1:DDJ-ERGO AUX/MIC L

R 2:DDJ-ERGO AUX/MIC R

(4)Mix Recorder

・Source：INTERNAL

10.The preferences settings may be overwritten to the default settings after completing the setup wizard depending on the versions of TRAKTOR PRO 2. When using DDJ-ERGO, the following audio settings are minimal requirements. Please ensure that you go through the setup procedures.

(1) Audio Setup

・Audio Device: PIONEER DDJ ASIO (For Windows users)

DDJ-ERGO(For Mac users)

11.Close the TRAKTOR PRO 2, power off the DDJ-ERGO and turn it on again, and reboot the TRAKTOR PRO 2.

Now, you have completed all the settings.

・To operate TRAKTOR PRO 2 using the buttons of DDJ-ERGO, see the separate “Hardware Diagram for TRAKTOR PRO 2”.

・TRAKTOR PRO 2 is a product of Native Instruments.

In principle, Pioneer is not in the position of answering any inquiries on the usage of the software itself. For further details, please refer to the manual of TRAKTOR and other resources.