Connecting the units
Connection diagram
1Special red battery wire
After completing all other amplifier connec- tions, finally connect the battery wire terminal of the amplifier to the positive (+) battery terminal.
2Ground wire (Black)
Connect to metal body or chassis.
3Car stereo with RCA output jacks (sold sepa- rately)
4External output
If only one input plug is used, do not connect anything to RCA input jack B.
5Connecting wire with RCA pin plugs (sold se- parately)
6RCA output jack
7RCA input jack A
8RCA input jack B
Section
03
9 | Amplifier with RCA input jacks (sold sepa- | English |
|
rately)
aSpeaker output terminals
Please see the following section for speaker connection instructions. Refer to Connections when using the speaker input wire on page 10.
bFuse (25 A) × 2
cSystem remote control wire (sold separately) Connect male terminal of this wire to the sys- tem remote control terminal of the car stereo (SYSTEM REMOTE CONTROL). The female terminal can be connected to the
dFuse (30 A) × 2
eGrommet
fRear side
gFront side
Note
INPUT SELECT (input select) switch must be set. For details, see Setting the Unit on page 5.
Before connecting the amplifier
WARNING
!Secure the wiring with cable clamps or adhe- sive tape. To protect the wiring, wrap sections in contact with metal parts in adhesive tape.
!Never cut the insulation of the power supply to feed power to other equipment. Current ca- pacity of the wire is limited.
CAUTION
!Never shorten any wires, the protection circuit may malfunction.
En | 7 |