English
2.Screw an supplied screw into the speaker mounting hole (lower of the two) at the top, rear of the flat panel
display.
Do not tighten it all the way yet. Leave it loose, with about 5 mm left to tighten.
Speaker |
| |
Mounting | Top, rear of flat | |
Hole | ||
panel display | ||
| ||
| Top of flat panel display | |
| 5 mm |
Leave a space of about 5 mm
3.Hang the speaker bracket on the screw you installed at the top by passing the wide part over it and lowering into the slot; screw in the
lower screw temporarily.
After passing the wide part of the hole of the speaker bracket (top) over the screw, lower the speaker onto it.
After passing the wide part of the hole over the screw, lower the speaker.
Tighten with the provided screw the bottom speaker bracket to the flat panel display temporarily (one place bottom).
4.Adjust the position of the speaker and then tighten the upper and lower screws firmly.
5.Tighten the two screws, at the top and bottom for each speaker (total of four screws), thus fixing the speakers to the flat panel display.
6.Pass the supplied speaker cable between the speaker and the flat panel display (below the speaker bracket) from below.
7.Connect the speaker cables to the speaker (see next page).
8.Insert the cable in the groove on the speaker.
Speaker Cable | Speaker |
| |
| Terminal |
Insertion in groove
9.Connect the other end of the speaker cables to the rear of flat panel display (see next page).
10
