English
10. Bundling the cables. | When using the hung on |
Follow the steps below to attach the cable clamp, an | wall unit: |
accessory of the flat panel display. |
1 ) Thread the clamp band through the holder and bundle the cable(s) in the cable clamp.
2 ) Push and hold the levers then insert the hook into an appropriate hole on the rear of the flat panel display.
3 ) Pull up the clamp band to lock.
1
2
4 ) Confirm that the cable clamp is seated firmly in the panel.
NOTE:
Avoid pinching or creating pressure points when routing or bundling cables.
NOTE:
First lay the flat panel display on top of a soft sheet etc., then attach the speakers.
1.Attach the speakers to the flat panel display (See procedures 1 to 10 on
pages 9 to 12).
Connect the other cables and power cord to the flat panel display.
2.Place the flat panel display on the mounting fittings of the hung on
wall unit.
For details, refer to the operating instructions supplied with the hung on wall unit.
Caution
Do not move the flat panel display by holding these speakers or speaker brackets. This could result in injury or damage to the brackets. When moving the flat panel display, hold by the top and handles.
To remove the clamp band, pull and hold the latch to release.
To remove the cable clamp, push and hold the levers then pull it out from the hole.
Latch
Lever
Lever
NOTE:
The longer a clamp is in place, the better chance of deterioration. An older clamp is more easily damaged while being removed and may not be reusable.
Rear of flat panel display
CABINET MAINTENANCE
•Use a polishing cloth or dry cloth to wipe off dust and dirt.
•When the cabinet is very dirty, wipe with a soft cloth moistened with
They may damage the surface of the cabinet.
•Never use thinner, benzine, insecticide sprays and other chemicals on or near the cabinets, since these will corrode the surfaces.
•When a chemical cloth is used, read the cautions for the chemical cloth carefully.
Cable clamp | Speaker cable |
Cable clamp |
12