Section

14Menu operations

3Turn the ignition switch to ON or ACC. If the car’s air conditioner or heater is turned on, turn it off. Noise from the fan in the air conditioner or heater may prevent correct auto EQ.

4Display the system menu.

Refer to Introduction of menu operations on page 54.

5Touch Auto EQ Measurement to enter auto EQ measurement mode.

6Plug the microphone into the micro- phone input jack on this unit.

(AVH-P4200DVD)

(AVH-P3200DVD/AVH-P3200BT)

7 Touch Start to start auto EQ.

8When the 10-second countdown starts, get out of the car and close the door within

10seconds.

A measurement tone (noise) is emitted from the speakers, and auto EQ measurement be- gins.

When auto EQ is completed, Complete is dis- played.

When the car’s interior acoustic characteris- tics cannot be measured correctly, an error message will be displayed. (Refer to Under-

standing auto EQ error messages on page 77.)

# It takes about nine minutes for auto EQ mea- surement to be completed when all the speakers

are connected.

# To stop auto EQ, touch Stop.

# To cancel auto EQ measurement mode during this procedure, touch the following touch panel key.

Canceling auto EQ measurement mode.

9Store the microphone carefully in the glove compartment or another safe place. If the microphone is subjected to direct sun- light for an extended period, high tempera- tures may cause distortion, color change or malfunction.

10Press h(eject) to close the panel. (AVH-P4200DVD only)

Note

(AVH-P4200DVD)

Do not press h (eject) to open or close the panel when you are using the microphone.

66 En