Appendix

Additional Information

iPod

 

Message

Cause

Action

 

 

 

 

 

Format Read/

Sometimes there

Wait until the mes-

Ready

is a delay be-

sage disappears

 

 

tween the start of

and you hear

 

 

playback and

sound.

 

 

when you start to

 

 

 

hear any sound.

 

 

 

 

Error-02-6X/-

Communication

Disconnect the

9X/-DX

failed.

cable from the

 

 

 

iPod. Once the

 

 

 

iPod's main menu

 

 

 

is displayed, recon-

 

 

 

nect the iPod and

 

 

 

reset it.

 

 

 

 

 

 

iPod failure

Disconnect the

 

 

 

cable from the

 

 

 

iPod. Once the

 

 

 

iPod's main menu

 

 

 

is displayed, recon-

 

 

 

nect the iPod and

 

 

 

reset it.

 

 

 

Error-02-67

The iPod firm-

Update the iPod

 

 

ware versions are

version.

 

 

old.

 

 

 

 

 

 

 

Message

Cause

Action

 

 

 

 

 

 

 

 

Error-8D

Built-in FLASH

Turn the ignition

 

 

 

ROM encoun-

OFF and ON.

 

 

 

tered an error

 

 

 

 

SD source can-

Tag information

Wait until tag

not be se-

is being trans-

transfer is com-

lected during

ferred to the

plete.

tag transfer.

iPod.

 

 

 

 

 

 

Bluetooth

 

Message

Cause

Action

 

 

 

 

 

Error-10

The power failed

Turn the ignition

 

 

for the Bluetooth

switch OFF and

 

 

module of this

then to ACC or ON.

 

 

unit.

If the error mes-

 

 

 

sage is still dis-

 

 

 

played after

 

 

 

performing the

 

 

 

above action,

 

 

 

please contact

 

 

 

your dealer or an

 

 

 

authorized Pioneer

 

 

 

Service Station.

 

 

 

 

Information Additional

Stop

There are no

Transfer songs to

 

songs.

the iPod.

 

 

 

 

There are no

Select a list that

 

songs in the cur-

contains songs.

 

rent list.

 

 

 

 

iTunes tagging

 

Message

Cause

Action

 

 

 

 

 

iPod full. Tags

Memory used for

Sync the iPod with

not trans-

tag information

iTunes and clean

ferred.

on the iPod is

up the tagged play-

 

 

full.

list.

 

 

 

Memory full.

This unit’s flash

Connect the iPod

Tags not

memory used as

to this unit and

stored.

the temporary

transfer this unit’s

 

 

storage area is

tag information to

 

 

full.

the iPod.

 

 

 

Tags trans-

This unit’s tag in-

Check the iPod

ferred failed.

formation cannot

and try again.

 

 

transfer to the

 

 

 

iPod.

 

 

 

 

 

Understanding auto EQ error messages

When correct measurement of the car’s interior acoustic characteristics is not possible using auto EQ, an error message may appear on the display. In such cases, refer to the table below to see what the problem is and how it may be corrected. After checking, try again.

 

Message

Cause

Action

 

 

 

 

 

Error. Please

The microphone

Plug the optional

check MIC.

is not connected. microphone se-

 

 

 

curely into the

 

 

 

jack.

 

 

 

 

Tag store

Tag information Try again.

failed.

cannot be stored

 

in this unit.

 

 

En 77