Pioneer P7200HD operation manual Operating this unit

Operating this unit

Section

02

Fader/Balance (fader/balance adjustment)

1Push M.C. up or down to adjust front/rear speaker balance.

F15 to R15 is displayed as the front/rear speaker balance moves from front to rear.

!F/R 0 is the proper setting when only two speakers are used.

!When the rear output setting is Rear SP :S/W, you cannot adjust front/rear speaker balance. Refer to S/W control (rear output and subwoo- fer setting) on page 17.

2Push M.C. left or right to adjust left/right speaker balance.

L15 to R15 is displayed as the left/right speaker balance moves from left to right.

Powerful (equalizer recall)

1Push M.C. left or right to select an equalizer curve. Powerful—Natural—Vocal—Custom1—Cus- tom2—Flat—Super bass

!When Flat is selected no adjustments are made to the sound.

100 Hz (equalizer adjustment)

You can adjust the currently selected equalizer curve setting as desired. Adjusted equalizer curve settings are memorized in Custom1 or Custom2.

!A separate Custom1 curve can be created for each source. If you make adjustments when a curve other than Custom2 is selected, the equali- zer curve settings will be memorized in Custom1.

!A Custom2 curve can be created common to all sources. If you make adjustments when the Cus- tom2 curve is selected, the Custom2 curve will be updated.

1Recall the equalizer curve you want to adjust.

2Push M.C. left or right to select the equalizer band to adjust. 100Hz—315Hz—1.25kHz—3.15kHz—8kHz

3Push M.C. up or down to adjust the equalizer curve.

+6 to –6 is displayed as the equalizer curve is in- creased or decreased.

LOUD (loudness)

Loudness compensates for deficiencies in the low- and high-frequency ranges at low volume.

1Press M.C. to turn loudness on or off.

2Push M.C. left or right to select the desired set- ting.

Low (low)—Mid (mid)—High (high)—OFF (off)

Sub W.1 (subwoofer on/off setting)

This unit is equipped with a subwoofer output which can be turned on or off.

1Press M.C. to turn subwoofer output on or off.

2Push M.C. left or right to select the phase of sub- woofer output.

Push M.C. left to select reverse phase and Re- verse appears in the display. Push M.C. right to select normal phase and Normal appears in the display.

Sub W.2 (subwoofer adjustment)

When the subwoofer output is on, you can adjust the cut-off frequency and the output level of the subwoo- fer.

Only frequencies lower than those in the selected range are outputted from the subwoofer.

1Push M.C. left or right to select cut-off frequency. 50Hz—63Hz—80Hz—100Hz—125Hz

2Push M.C. up or down to adjust the output level of the subwoofer.

Each time M.C. is pushed up or down, subwoofer level increases or decreases. +6 to -24 is dis- played as the level is increased or decreased.

Bass (bass boost)

1Push M.C. up or down to select a desired level.

0 to +6 is displayed as the level is increased or de- creased.

HPF (high pass filter adjustment)

When you do not want low sounds from the subwoo- fer output frequency range to play from the front or rear speakers, turn on the HPF (high pass filter). Only frequencies higher than those in the selected range are output from the front or rear speakers.

1Press M.C. to turn high pass filter on or off.

2Push M.C. left or right to select cut-off frequency. 50Hz—63Hz—80Hz—100Hz—125Hz

English

En

15