06Use Other Equipment With Your Flat Panel Display
6Use Other Equipment With Your Flat Panel Display
Although earlier sections have mentioned other equipment for playing back video, this section provides control and operation information for specific types of equipment.
6.1Program the Remote Control to Operate Other Equipment
To operate other equipment or devices through your flat panel display, program the panel’s remote control with the equipment’s manufacturing code. A manufacturing code is a series of numbers that identify the type of device and the brand. These codes are available in the section entitled “Manufacturer Codes to Program into the Remote Control” in Appendix 9.1 of this manual.
6.1.1Use the Learning Function
The Learning function allows the panel’s remote control to memorize codes | 1 | 2 | 3 | 4 |
to control other devices. |
|
|
|
|
| 5 | 6 | 7 | 8 |
|
| SUB |
| PIP |
To set the Learning function to On, follow the directions below. |
| INPUT |
|
|
SELECT | MONITOR STB | BDP | EDIT/LEARN | |
1 ) Press SELECT to choose the other device. |
| LD | VCR | |
| CBL | DVD |
| |
|
| SAT | DVR |
|
2 ) Simultaneously press the EDIT/LEARN and 2 buttons to begin.
The selected mode indicator flashes when the remote control is ready to be programmed.
3 ) Use the number buttons to learn a manufacturing code. The mode indicator lights up.
The Learn session is canceled in 30 seconds and the indicator begins blinking again. When the indicator flashes, the selected device’s remote is memorized.
When you press a button that cannot be learned, the indicator continues to blink.
To exit the Learn mode before it finishes, press EDIT/LEARN.
4 ) Press EDIT/LEARN again to exit the Lean mode after the code is confirmed.
: | Notes: The Learn session cancels if: | 2 cm to 5 cm (0.8 inches to 2.0 inches) | |
| |||
| • no operation is performed for more than one |
|
|
| minute after having pressed EDIT/LEARN and 2 |
|
|
| (the mode indicator is flashing) |
|
|
| • you press SELECT |
|
|
| Code transmission finishes in approximately two |
|
|
| seconds. Do not interrupt the process until the |
|
|
| transmission is complete. |
|
|
| When using any of the receiver buttons | Remote control | Remote control of |
| (Supplied accessory) | AV product | |
| (a, INPUT, or |
|
|
| code remains the same. |
|
|
46
En
