Pioneer manual Playback Delay, PRV-LX1as Recording Device, 8.4PRV-LX1as the Source Device

Models: PRV-LX1

1 20
Download 20 pages 54.1 Kb
Page 18
Image 18
8.2 Playback Delay

PRV-LX1 RS-422A Protocol

8.2 Playback Delay

When the PRV-LX1 is issued a play command, it experiences up to a +2 frames delay in the execution of the command. The decoding system requires 2 frames to accomplish setup.

8.3 PRV-LX1 as Recording Device

When issuing a “pause” command while recording, the PRV-LX1 continues recording within the same title/clip, maintaining continuous time-code.

*To issue a “pause” command the user must issue a “shuttle 0” command. This pauses the recording to insert a chapter mark at the closest GOP of encoded video then recording continues. The [Auto Chapter] setting should be set to manual.

*Issuing a “stop” command closes the recorded title/clip as defined by the DVD spec. All subsequent recordings via serial control start with a new title/clip and the LX1 begins generating new time-code within that title/clip.

8.4PRV-LX1 as the Source Device

When the PRV-LX1 is the source device being controlled via serial control with an NLE or edit control device, the following limitation applies.

When an external control device is controlling the LX1 and a “search and play” command is sent via serial control, the PRV-LX1 reports back frame numbers every 50ms. The PRV-LX1 cannot return the precise time-code. The unit may return the same value as requested earlier or may skip the frame while Recording or Playing.

*Manually record without using serial control when the recorder is to be used as a source. Or, if the external control device offers the ability to change the time-code query speeds, change the speed to 50ms to match the PRV-LX1.

Page 17 of 18

Page 18
Image 18
Pioneer manual Playback Delay, PRV-LX1as Recording Device, 8.4PRV-LX1as the Source Device