Pioneer SE-DIR800C manual Contents, Important symbols for good services

5 6 7 8

[ Important symbols for good services ]

In this manual, the symbols shown-below indicate that adjustments, settings or cleaning should be made securely. When you find the procedures bearing any of the symbols, be sure to fulfill them:

1. Product safety

You should conform to the regulations governing the product (safety, radio and noise, and other regulations), and should keep the safety during servicing by following the safety instructions described in this manual.

2. Adjustments

To keep the original performances of the product, optimum adjustments or specification confirmation is indispensable. In accordance with the procedures or instructions described in this manual, adjustments should be performed.

3. Cleaning

For optical pickups, tape-deck heads, lenses and mirrors used in projection monitors, and other parts requiring cleaning, proper cleaning should be performed to restore their performances.

4. Shipping mode and shipping screws

To protect the product from damages or failures that may be caused during transit, the shipping mode should be set or the shipping screws should be installed before shipping out in accordance with this manual, if necessary.

5. Lubricants, glues, and replacement parts

Appropriately applying grease or glue can maintain the product performances. But improper lubrication or applying glue may lead to failures or troubles in the product. By following the instructions in this manual, be sure to apply the prescribed grease or glue to proper portions by the appropriate amount.For replacement parts or tools, the prescribed ones should be used.

CONTENTS
SAFETY INFORMATION	2
1. SPECIFICATIONS	4
2. EXPLODED VIEWS AND PARTS LIST	6
2.1 PACKING	6
2.2 TRANSMITTER SECTION	8
2.3 HEADPHONE SECTION	10
3. BLOCK DIAGRAM AND SCHEMATIC DIAGRAM	12
3.1 MAIN, POWER, L.PHOTO and R.PHOTO PCB ASSYS	12
3.2 PCB ASSY	14
4. PCB CONNECTION DIAGRAM	16
4.1 L.PHOTO and R.PHOTO PCB ASSYS	16
4.2 POWER PCB ASSY	17
4.3 MAIN PCB ASSY	18
4.4 PCB ASSY	20
5. PCB PARTS LIST	24
6. ADJUSTMENT	26
7. GENERAL INFORMATION	27
7.1 DIAGNOSIS	27
7.1.1 TROUBLE SHOOTING	27
7.1.2 Disassembly	32
7.2 IC	34
7.3 ABOUT LOT MARK INDICATION	53
8. PANEL FACILITIES	54

A

B

C

D

E

F

5 6

SE-DIR800C

3

7 8