12Additional information
Symptom | Remedy |
Can’t select some Input | • Check the Input Skip settings in the Input Setup menu. |
functions by the INPUT | • Check the HDMI Input assignment in the Input Setup menu then try OFF. |
SELECTOR on the front panel |
|
or the INPUT SELECT button on |
|
the remote control. |
|
|
|
There seems to be a time lag | • See Automatically conducting optimum sound tuning (Auto MCACC) on page 37 to set up your |
between the speakers and the | system again using MCACC (this will automatically compensate for a delay in the subwoofer output). |
output of the subwoofer. |
|
|
|
The maximum volume | • Check that the Volume Limit is set to OFF (see Volume Setup on page 87). |
available (shown in the front | • The channel level setting may be over 0dB. |
panel display) is lower than the |
|
+12dB maximum. |
|
|
|
ADAPTER PORT
Symptom
The Bluetooth wireless technology device cannot be connected or operated. Sound from the Bluetooth wireless technology device is not emitted or the sound is interrupted.
Remedy
•Check that no object that emits electromagnetic waves in the 2.4 GHz band (microwave oven, wireless LAN device or Bluetooth wireless technology apparatus) is near the unit. If such an object is near the unit, set the unit far from it. Or, stop using the object emitting the electromagnetic waves.
•Check that the Bluetooth wireless technology device is not too far from the unit and that obstructions are not set between the Bluetooth wireless technology device and the unit. Set the Bluetooth wireless technology device and the unit so that the distance between them is less than about 10 m and no obstructions exist between them.
•Check that the Bluetooth ADAPTER and the ADAPTER PORT of the unit are correctly connected.
•The Bluetooth wireless technology device may not be set to the communication mode
supporting the Bluetooth wireless technology. Check the setting of the Bluetooth wireless technology device.
•Check that pairing is correct. The pairing setting was deleted from this unit or the Bluetooth wireless technology device. Reset the pairing.
•Check that the profile is correct. Use a Bluetooth wireless technology device that supports A2DP profile and AVRCP profile.
Video
Symptom | Remedy |
No image is output when an | • Check the video connections of the source component (see page 27). |
input is selected. | • For HDMI, or when digital video conversion is set to OFF and a TV and another component are |
| connected with different cords (in Setting the Video options on page 61), you must connect your TV |
| to this receiver using the same type of video cable as you used to connect your video component. |
| • Make sure the input assignment is correct for components connected using component video or |
| HDMI cables (see The Input Setup menu on page 39). |
| • Check the video output settings of the source component. |
| • Check that the video input you selected on your TV is correct. |
| • Some components (such as video game units) have resolutions that may not be converted. If |
| adjusting this receiver’s Resolution setting (in Setting the Video options on page 61) and/or the |
| resolution settings on your component or display doesn’t work, try switching Digital Video |
| Conversion (in Setting the Video options on page 61) to OFF. |
|
|
Can’t record video. | • Check that the source is not |
| • The video converter is not available when making recordings. Check that the same type of video |
| cable is used for connecting both the recorder and the video source (the one you want to record) to |
| this receiver. |
|
|
Noisy, intermittent, or distorted | • Sometimes a video deck may output a noisy video signal (during scanning, for example), or the |
picture. | video quality may just be poor (with some video game units, for example). The picture quality may |
| also depend on the settings, etc. of your display device. Switch off the video converter and reconnect |
| the source and display device using the same type of connection (component or composite), then |
| start playback again. |
|
|
92
En