Pioneer VSX-9100TX operating instructions Use cursor left/right to select Learn then press Enter

Controlling the rest of your system

Programming signals from other remote controls

If the preset code for your component is not available, or the available preset codes do not operate correctly, you can program signals from the remote control of another component. This can also be used to program additional operations (buttons not covered in the presets) after assigning a preset code.

1While pressing the RECEIVER button, press and hold the 1 button.

The remote LCD display shows SETUP.

2Press the MULTI CONTROL button for the component you want to control.

The LCD on the remote displays the component you want to control.

•You can’t assign the RECEIVER button.

3 Use (cursor left/right) to select LEARN then press ENTER.

PRES KEY shows in the LCD display.

• To exit or cancel press RECEIVER.

4Point the two remote controls towards each other then press the button that will be doing the learning on this receiver’s remote control.

PRES KEY starts flashing to indicate the remote is ready to accept a signal.

•The remote controls should be 1–2 inches apart.

1 – 2 inches

5Press the corresponding button on the other remote control that is sending (teaching) the signal to this receiver’s remote control.

For example, if you want to learn the playback control

signal, press and hold for a couple of seconds. The LCD display will show OK if the operation has been learned.

If for some reasons the operation hasn’t been learned the LCD will display ERROR briefly and then display PRES KEY again. If this happens, keep pressing the (teaching) button as you vary the distance between the two remotes, until the LCD display shows OK.

09

Certain buttons represent operations that cannot be learned from other remote controls. The buttons available are shown below:

RECEIVER	INPUT	SOURCE
	SELECT

DVD/LD		TV/SAT	DVR/VCR	TV CONT
		MULTI CONTROL
CD		CD-R/TAPE	TUNER	RECEIVER
INPUT ATT		FLDIMMER		SR
	+10			DISC
				ENTER
D.ACCESS				CLASS
TOP MENU				MENU
		TUNE
DTV MENU	ST		ST
T.EDIT		ENTER		BAND
SYSTEM TUNE
GUIDE SETUP				RETURN
		TV CONTROL
TVVOL		INPUT	TV CH	VOL
		SELECT
DTVON/OFF		REC	DTVINFO	MUTE
TUNER			RECSTOP
DISPLAY
MPX		CHRETURN	HDD	DVD
AUDIO		SUBTITLE
			CH	CH
		RECEIVER CONTROL
THX		STANDARD	ADV.SURR	STEREO
		ACOUSTIC	SIGNAL	MIDNIGHT/
AUTO SURR		EQ	SELECT	LOUDNESS
SHIFT		EFFECT	SLEEP	DIALOG E
		/CHSEL

RECEIVER

6To program additional signals for the current component repeat steps 4 and 5.

To program signals for another component, exit and repeat steps 1 through 5.

7Press the RECEIVER button to exit and store the operation(s).

Note

•Some commands from other remote controls cannot be learned, but in most cases the remotes just need to be moved closer together or farther apart.

•If the remote LCD shows ERROR, it may also mean the memory is full. See Erasing one of the remote control button settings below to erase a programmed button you’re not using to free up more memory.

• TV CONTROL buttons (TV ,TV VOL +/–,TV CH +/– and INPUT SELECT) can only be learned after selecting TV CONT.

51

En