Pioneer VSX-9110TXV-K Other connections Bi-wiring your speakers, Connecting additional amplifiers

08Other connections

Bi-wiring your speakers

The reasons for bi-wiring are basically the same as bi- amping, but additionally, interference effects within the wire could be reduced, producing better sound. Again, to do this your speakers must be bi-wireable (that is they must have separate terminals for the high and low frequencies). When bi-wiring, make sure you’ve selected Normal (SB) or 2nd Zone in Surround back speaker setting on page 35.

Connecting additional amplifiers

This receiver has more than enough power for any home use, but it’s possible to add additional amplifiers to every channel of your system using the pre-outs. Make the connections shown below to add amplifiers to power your speakers.

•Before making or changing the connections, switch off the power and disconnect the power cord from the AC outlet.

•To bi-wire a speaker, connect two speaker cords to the speaker terminal on the receiver.

Using a banana plug for the second connection is recommended.

Caution

• Make sure you use a parallel (not series, which are

fairly uncommon) connection when bi-wiring your

speakers.

• Don't connect different speakers from the same

terminal in this way.

AM LOOP		CENTER	PRE OUT
	L		L	L (Single)
OUT
IN
3						R
	R		R SUR-
		SUB			SURROUND
	FRONT	WOOFER		ROUND	BACK
				12V TRIGGER
				(DC OUT 12 V /
					50 mA MAX)
OUT	IN	MONITOR		MULTI-ROOM & SOURCE
		OUT		MONITOR		ROOM 2(ZONE 2)
						R	L
				OUT
OUT	IN	L		CENTER	L		L
DVR/VCR2		R		SUB	R		R
		FRONT			SUR-		SURROUND
				WOOFER ROUND			BACK
		MULTI CH IN

VSX-9110TXV

ANALOG

INPUT

L R

Front channel amplifier

ANALOG

INPUT

Center channel amplifier (mono)

ANALOG

INPUT

L R

Surround channel amplifier

ANALOG

INPUT

L R

Surround back channel amplifier

ANALOG

INPUT

Powered subwoofer

•You can use the additional amplifier on the surround back channel pre-outs for a single speaker as well. In this case plug the amplifier into the left (L (Single)) terminal only.

•The sound from the surround back terminals will depend on how you have configured the Surround back speaker setting on page 35.

•To hear sound only from the pre-outs, switch the speaker system to OFF, or simply disconnect any speakers that are connected directly to the receiver.

•If you’re not using a subwoofer, change the front speaker setting (see Speaker Setting on page 42) to

LARGE.

52

En