Using other functions
•Press RECEIVER then press SLEEP repeatedly to set the sleep time.
| 30 min |
| 60 min | ||
|
| ||||
|
| Off |
|
| 90 min |
|
|
|
| ||
•You can check the remaining sleep time at any time by pressing SLEEP once. Pressing repeatedly will cycle through the sleep options again.1
Dimming the display
You can choose between four brightness levels for the front panel display. Note that when selecting sources, the display automatically brightens for a few seconds.
HDMI2 | XM RADIO | ROOM 2 | |
iPod | HDMI1 | TUNER | RECEIVER |
| SLEEP | VIDEO | ANALOG |
|
| SEL | ATT |
| SR+ | DIMMER | MIDNIGHT/ |
|
|
| LOUDNESS |
| DIALOG E | S.RETRIEVER |
|
DACCESS
•Press RECEIVER then press DIMMER repeatedly to change the brightness of the front panel display.
Switching the speaker impedance
We recommend using speakers of 8 Ω with this system, but it is possible to switch the impedance setting if you plan to use speakers with a 6 Ω impedance rating. Use the front panel controls to do this.
• With the receiver in standby, press STANDBY/ ON while holding down the SPEAKERS button. Each time you do this, you switch between the impedance settings:
•SP 6 OHM – Use this setting if your speakers are rated at 6 Ω.
•SP 8 OHM – Use this setting if your speakers are rated at 8 Ω or more.
10
1Press STATUS to check the system settings. These appear on both the OSD and the front panel display.2
STATUS
DOLBY DIGITAL 3/2.1
PCM 96+DOLBY PLII MS
Signal | Select | : AUTO |
SBch | Processing: OFF | |
Retriever | : ON | |
Video | Select | : OFF |
MCACC Position : M1 | ||
Room 2 | : DVD | |
The front panel display shows each of the following settings for three seconds each:
Input source | Listening mode |
|
|
Signal select | Surround Back Processing |
|
|
Sound Retriever | Video Select |
|
|
MCACC Position | ROOM 2 |
|
|
2When you’re finished, press STATUS again to switch off the display.
Resetting the system
Use this procedure to reset all the receiver’s settings to the factory default. Use the front panel controls to do this.
1Switch the receiver into standby.
2While holding down the front panel TONE button,
press and hold STANDBY/ON for about three seconds.
The display shows RESET?.
3Press the front panel ENTER button. The display shows RESET OK?.
4Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the receiver has been reset to the factory default settings.
•Note that all settings will be saved, even if the receiver is unplugged.
Checking your system settings
Use the status display screen to check your current settings for features such as surround back channel processing and your current MCACC preset.
AUDIO SUBTITLE HDD
DISPCH
DVD
CH 
STATUS | SIGNAL SEL | SBch | STEREO |
MULTI OPE | THX | STANDARD | ADV.SURR |
SHIFT PHASE MCACC S.DIRECT
Note
1You can also switch off the sleep timer simply by switching off the receiver.
2If the Pure Direct mode is switched on, some settings above will show OFF, even though they are on.
63
En
