Pioneer XW-HT1 manual Before you start Using the remote control, English, Inserting the battery

Models: XW-HT1

1 47
Download 47 pages 4.92 Kb
Page 9
Image 9
Before you start

Before you start

Using the remote control

Inserting the battery

Insert the lithium battery (CR2025) into the remote control as shown below. When you notice a decrease in the operating range, replace the battery in the same manner.

1

2

4

3

1Insert a screwdriver (or other sharp object) where shown to loosen the battery casing.

2Pull out the battery casing.

3Place the battery in the casing.

Make sure the side of the battery is facing up when you place it in the space provided.

4Push the battery casing back into place.

Make sure the battery casing is inserted properly before pushing it in.

Inserting the battery Caution

When using lithium batteries, please observe the following:

Danger of explosion if the battery is incorrectly replaced. Replaced only with the same or equivalent type recommended by the manufacturer.

Dispose of used battery cells immediately after replacement. Keep away from children.

If swallowed, please contact a doctor immediately.

Lithium batteries may present a fire or chemical burn hazard if misused. Do not disassemble, heat above 100˚C (212˚F), or incinerate.

Make sure that the plus and minus end of the battery match the indications in the battery compartment.

Remove the battery if the unit isn’t going to be used for a month or more.

When disposing of used batteries, please comply with governmental regulations or environmental public instruction’s rules that apply in your country or area.

Be careful never to insert the battery holder in a wrong orientation, for this will result in damage.

01

English

9

En

Page 9
Image 9
Pioneer XW-HT1 manual Before you start Using the remote control, English, Inserting the battery