Pitco Frialator Ensure that the tank contents have been, L80-029Rev 5 10/07

Follow this procedure for Installation of Self Cleaning burners and SCBS arm:

a.Disconnect the control harness from the main gas valve and tuck it out the way to avoid damaging the harness during this procedure.

b.If your appliance has a solid-state control (or auxiliary thermostat) behind the door, remove it at this time. With a 5/16” nut driver remove the two self-threading screws that mount the control to the appliance, disconnect the control harness and tuck it out of the way to avoid damaging the harness during this procedure. Be sure to store the control in a safe place to avoid accidental damage to it.

c.Using a 7/16” wrench, remove the pilot tubing from the gas valve by turning the brass fitting counter- clockwise. There is no need to remove the pilot from the burner assembly.

WARNING

Ensure that the tank contents have been

drained before executing this step!

d.Using an 11/16” wrench or socket, loosen and remove the drain valve nut and washer, and remove the blue drain valve handle. Note: You may want to place the nut and washer back on the valve stem for safekeeping.

L80-029 Rev 5 10/07 2