Planar LC1502R user manual Mounting, Description

8

3.External Dimming Connector Connector type: Molex Micro Fit 3.0

Mating connector: Molex 43025-0600 (housing) and Molex 43030 (terminals)

External Dimming Connector Pin Configuration and Description

Pin	Name	Description
1	Ground	Electrical ground
2	Reserved	For factory use only, leave unconnected
3	DIM_Input	0-5V analog input for external dimming, connect to wiper of
		dimming pot if used
4	/Ext_DIM,	Input to determine brightness control mode; has 10k pull up to +5V
		Logic high (or unconnected) = Automatic Brightness Control mode
		Logic low = Manual Brightness Control mode
5	Ground	Electrical ground; connect to lower leg of dimming potentiometer
		if used
6	Vref	+5V reference voltage output with 470 ohm series resistance;
		connect to upper leg of dimming potentiometer if used

4. Cooling Kit Power Output Connector

Note: There is no need to connect to this connector. Information is shown for reference only. If a

Cooling Kit option is ordered, the required cooling kit power cable will be installed at the factory.

Optional Cooling Kit Pin Configuration

Pin Description

1Switched Return

2+12V output

Mounting

M4 threaded holes are provided in the sides of the monitor housing for mounting purposes. The blind holes will accommodate 10 mm long screws. See the mechanical outline drawing 076-0579-00 at www.planar.com/support for details.