PLANET Technology Corp.

GRT-101/401 User’s Manual

3.12.4 WAN IP address

Note: This sub-section is for routing mode operation with protocol of “Ethernet” and/or “IPoA” only. For PPP connections, it is unnecessary to set the WAN port IP address and subnet mask.

To set the WAN 3 with IP address of 192.168.3.3 and subnet mask of 255.255.255.0, follow the following example:

admin# setup wan 3 address 192.168.3.3 255.255.255.0

To review the new configuration you have configured, type:

admin# setup wan 3 list

 

 

WAN Interface Parameters

 

 

Int.

Link

IP Address/

Netmask VPI/

VCI Encap. QoS PCR

---- -------- ----------------------------- --------- ------ --- ----

 

WAN 1

Disable

 

 

 

WAN 2

Disable

 

 

 

WAN 3

Ethernet

192.168.3.3/

255.255.255.0 0/

135 VC-Mux CBR 512

WAN 4

Disable

 

 

 

WAN 5

Disable

 

 

 

WAN 6

Disable

 

 

 

WAN 7

Disable

 

 

 

WAN 8

Disable

 

 

 

To save the new WAN port configuration, enter:

admin# write

3.12.5 ISP profile for PPP

Note: This sub-section is for routing mode operation only.

If your local ISP uses protocols of “PPPoA” or “PPPoE” over the ATM VC, you may need to setup the username and password information provided from your local ISP. The maximum length of username and password for ISP setting is limited to 51. The following command configures the ISP profile for WAN 3 with username “pppoa3@isp.com”, password “Fuyg47ds”, and idle timeout of 10 minutes:

-58-